HOOKE ROAD BXG.3043-S Wrangler JL Rear Fender Flares Installation Guide
- May 15, 2024
- HOOKE ROAD
Table of Contents
MAKE A DIFFERENCE
Rear Fender Flares
BXG.3043-S
(1) Contents:
BXG.3043-S Wrangler JL Rear Fender Flares
Real fender flares
| Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|
| 12 | Button Head Socket Cap Bolts Screws | M6*25 | |
| 12 | Flat Washer | M6201.5 | |
| 12 | Rivet Nut | M6 | |
| 2 | Rubber Stopper | 24 | |
| 1 | Rivet Nut Tool |
Tools required:
a. 4mm Hex Bit Socket;
b. 10mm Wrench;
c. 9mm Drill;
d. Power Drill;
e. Marker Pen;
Installation time:
About 1.5 hours, 2-3 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.3043-S), please scan the QR code.
https://drive.google.com/drive/folders/1Ix9Sr2m4d3lcIg14tIHNmgV7zx0v- SY0?usp=share_link
Installation instruction:
Driver Side Installation:
Step 1: Remove the factory rear fender flares. Ready to install our
product.
Step 2: Please drill this new hole in the left. Lift up the rear fender flares. Align the vehicle frame, and then make a marker with the marker pen, at last use the 9mm drill to drill this hole with the power drill.
Step 3: Enlarge the right hole with the power drill in order to install the rivet nut.
Step 4: Install the rivet nut in the six holes with the rivet nut tool (If you use our rear inner fender liners, you only install the rivet nut in the most left and the right holes). the rivet nut tool instruction: The 6mm allen wrench use in the top, 14mm wrench stuck on the middle nut. Put the rivet nut in the hole, screw the threaded end of the rivet nut tool into the rivet nut (Notice: Must be screwed to the bottom), finally unscrew the rivet nut tool out.
Step 5: At last, lift up the rear fender flares. Align the vehicle frame, install it with the Button Head Socket Cap Bolts Screws (M625), Flat Washer (M620*1.5).
Step 6: Repeat the above installation steps in the passenger side. Recover the
factory or modified inner fender liners.
Step 7: The installation is complete. We hope you enjoy a wonderful off-road
life with this quality Hooke Road product!
Attention:
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
Google Hooke Road to find your parts
@HookeRoad4x4
Post Your Jeep/Truck
w/Hashtag #hookeroad to Win Discount Every Week
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>