HOOKE ROAD BXG.7016-S Gladiator JT Flat Fender Flares Instruction Manual
- June 17, 2024
- HOOKE ROAD
Table of Contents
MAKE A DIFFERENCE
Rear Fender Flares
BNG.7016-S
Contents:
Rear Fender Flares
Driver Side| 
Passenger Side| 
Qty| Part Name| Size(mm)| Picture
---|---|---|---
10| Button Head Socket Cap Bolts Screws| M825|
10| Flat Washer| M820*1.5|
10| Flange Hex Lock Nuts| M8|
2| Protective Foam Cushion| |
Tools required:
a. 5mm Hex Bit Socket;
b. Drive Socket Ratchet Wrench;
c. 8mm socket;
Installation time:
About 2 hours, 1-2 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.7016-S), please scan the QR code.
https://drive.google.com/drive/folders/1i18fE4okvhI5v8HckLtus9AyJ6HTRKOv?usp=share_link
Installation instruction:
Rear Factory Flare Removal
Step 1: Use a 8mm socket to remove the bolts located along the interior
of the inner fender. Then, use a trim clip tool to remove clips located in
each corner of the fender.
Step 2: Remove the
fender flare by pulling the front section towards the front of the vehicle,
and the rear section towards the rear. Then pull the fender directly “away”
from the vehicle, to release the remaining clips.
On the JT, you should be able to reach around and squeeze the clips to remove
if needed.
Step 3: Use a trim clip tool
to remove the clips along the edge of the fender that remained in the vehicle.
Repeat process for the other side.
Passenger Side
Installation:
Note: This fender flare isn’t suitable for the factory inner fender, so we
use our inner fender with it installing together as example. We highly
recommend our inner fender for you.
Step 4: Before installation, please ensure this five installation holes.
As the picture showed. Step 5: Install the protective foam cushion on the
back of the rear fender flare, lift up the rear fender flare, and align it
with the factory installation holes of the vehicle. Step 6: Firstly, to
install the middle three holes first. Use the Button Head Socket Cap Bolts
Screws (M825), Flat Washer (M8201.5), Flange Hex Lock Nuts (M8). Don’t
tighten up those bolts.
Step 7: At
last, to install the both side holes. Use the Button Head Socket Cap Bolts
Screws (M825), Flat Washer (M8201.5), Flange Hex Lock Nuts (M8).
Tighten up those bolts together including the step 6 bolts.
Step 8: Repeat the same installation steps in the driver side.
Step 9: The installation is complete. We hope you enjoy a wonderful off-
road life with this quality Hooke Road product!
Attention:
- The product parts in this instruction may differ slightly from the actual product contents hut generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question ahout your purchase.
Google Hooke Road to find your parts.
Feel Free To Share Your Vehicle @HookeRoadéx4
With The Hashtag #hookeroad If You’d Like
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>