HOOKE ROAD BXG.3063-S Rear Bumper Installation Guide
- June 17, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.3063-S Rear Bumper
Specifications
- Model: BXG.3063-S
- Contents:
- 4 Hex Bolt Size(mm) M12*110
- 6 Hex Head Flange Bolts M14*40
- 2 Hex Bolt M12*30
- 2 Button Head Socket Cap Bolts Screws M8*20
- 6 Split Lock Washer D12
- 2 Split Lock Washer 10 Flat Washer D8 M12302
- 2 Flat Washer M8161.5
- 4 Hex Nut M12
- 2 Flange Hex Lock Nuts M8
- 2 D-ring
- 8 Cable Ties
- 4 Sensor Brackets 3*150mm
- Tools required:
- Drive Socket Ratchet Wrench
- 19mm Wrench
- 5mm Hex Bit Socket
- Installation time: About 1 hour, 1-2 people may be needed. Installation time may differ according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.3063-S), please scantheQRcode.
Installation Instructions
- Step 1: Remove the factory rear bumper, ready to install our bumper.
- Step 2: Insert the plug of the factory vehicle radar harness into the corresponding radar socket, secure the radar to the rear bumper using the sensor bracket, and fasten it with M4*16 screws. Use cable ties to secure the factory vehicle wiring harness in place.
- Step 3: Secure the license plate frame and the bumper using the M8*20 button head socket cap bolts screw.
- Step 4: Place the hitch receiver into the rear frame, then install the M12*110 hex bolts and nuts.
- Step 5: Put the Nut Plate Brackets into the vehicle (Only on the passenger side).
- Step 6: Lift up the bumper into the vehicle frame. Install the bumper with the M1440 hex head flange bolts or the factory hex head flange bolts. The bottom mounting position on the passenger side uses M1230 hex bolts. Tighten all bolts.
- Step 7: Install the D-ring into the D-ring mount.
- Step 8: The installation is complete. Enjoy your off-road adventures with this quality Hooke Road product.
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally do not affect the installation of the product.
- Please feel free to contact your distributor if you have any questions about your purchase.
FAQ
Q: How long does it take to install the rear bumper?
A: The installation typically takes about 1 hour with 1-2 people, but the time may vary based on your mechanical skill level.
Q: Can I install the bumper by myself?
A: While it’s recommended to have assistance during installation, it is possible to install the bumper alone with proper tools and precautions.
Q: Are additional tools required for installation?
A: The tools required for installation are a Drive Socket Ratchet Wrench, a 19mm Wrench, and a 5mm Hex Bit Socket as specified in the manual.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>