n-FAB NBF214B-TX Nerf Board Instruction Manual
- October 31, 2023
- n-FAB
Table of Contents
n-FAB NBF214B-TX Nerf Board
SPECIFICATION
HWKT-09617X
| QTY
---|---
BHCS- 09591X| M6X16MM BUTTON HEAD CAP SCREW| 24
FW-09601| M6 FLAT WASHER| 24
BHCS-09603| M6 flanged nut| 24
CARB-09609| 3/8″-16X1″ Gr 5 Steel Carriage Bolt| 12
FLNT-00664| 3/8-16 GRADE 8 STEEL
FLANGE NUT
| 12
HWKT-04239X| QTY
M10x25mm hex flanged bolt| 12
PARTS INCLUDED
| PARTS INCLUDED | QTY |
|---|---|
| Driver Side Running Board | 1 |
| Passenger Side Running Board | 1 |
| Rocker panel brackets | 6 |
| Step Plate | 4 |
INSTALLATION INSTRUCTIONS
Step 1: Identify Driver Side Nerf board.
Step 2: Install the supplied step plate (x2) to each Running Board using
the M6x20mm button head bolts, M6 nuts and M6 flat washer.
DO NOT OVER TIGHTEN
Step 3: Install (x3) mounting brackets to each attachment point with the
supplied 3/8”x1” carriage bolt and flanged 3/8” nut on the main tube. Hand
tighten for now. Repeat with passenger side.
NOTE: Mounting brackets will attached in the forward position with the
threaded part of the carriage bolt facing towards the rear of the vehicle.
Step 4: Install Nerf Board assembly to the factory mounting location using the supplied M810 flanged hex bolt (x6). Leave loose for now.
Step 5: There will be ½” of adjustment in the (x3) mounting bracket. Adjust to desired position and tighten to (20 ft,/lbs). Then tighten body mount brackets to (25-30 ft./lbs)
Step 7: Repeat steps 4-5 for the passenger side.
CUSTOMERS SUPPORT
12302 Shiloh Church Rd. Houston TX 77066 Phone (281) 880-6322 – Fax (281) 880-6325
I-SHEET PART NUMBER: INST-00285
PART NUMBER: NBF214B-TX
PRODUCT: NERF BOARD
APPLICATION: 21-22 FORD BRONCO 4DR
