n-FAB N2273CC Nerf Step Gloss Black Installation Guide
- June 13, 2024
- n-FAB
Table of Contents
n-FAB N2273CC Nerf Step Gloss Black Installation Guide
Components and Hardware
Tools for Installation
- 13mm socket
- Ratchet wrench
INSTALLATION
Step 1. Remove any OE step/running boards from the vehicle and discard.
Step 2. Clean any undercoating or debris from the threaded studs.
Step 3. Next, place (#1) Driver side step on the studs and secure with supplied (#3,#4) M8 flanged hex nut and M8 flat washer and loosely tighten for now.
(NOTE: Slide step forward until bracket makes contact with threaded stud.)
Step 4. After final adjustment fully tighten (x3) brackets to the factory
body mounts to (15-20 ft/lbs torque).
Step 5. Repeat process with passenger side step.
N-FAB® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
| EMAIL: techsupport@n-fab.com
FOR WARRANTY INFORMATION VISIT: WWW.N-FAB.COM
References
- Fab | A Digital Asset Marketplace for Content Creators
- N-Fab Steps, Running Boards & Accessories | RealTruck
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>