n-FAB HPD1980CC-TX Podium Hoop Step Installation Guide
- June 13, 2024
- n-FAB
Table of Contents
n-fab.com
nfabinc
I-SHEET PART NUMBER: INST-00302
PART NUMBER: HPD1980CC-TX
HPD1967QC-TX
PRODUCT: PODIUM HOOP STEP
APPLICATION: 2019-22 RAM 1500 CC QC
HPD1980CC-TX Podium Hoop Step
HARDWARE DESCRIPTION | QTY. |
---|---|
M8 – 1.25 HX FLANGED NUT | 18 |
10MMX25MM CARRIAGE BOLT | 12 |
10MM HEX FLANGED NUT | 12 |
PARTS INCLUDED | QTY |
--- | --- |
DRIVER SIDE | 1 |
PASSENGER SIDE | 1 |
MOUNTING BRACKET | 6 |
DO NOT USE IMPACT TOOLS
Step 1: Locate the driver side step rail.
Step 2: Install the (x6) mounting brackets to each attachment point on
the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave
loose for now.
** NOTE:** The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. ***
Step 3: Remove any steps and old hardware from the vehicle.
Step 4: On the inside rocker panel there will be three-attachment point consisting of three 8mm studs coming out from the panel. These studs may be covered in paint and will need to be cleaned before the installation.
Step 5: An additional person recommended for this step. Carefully install the Hoop step to the three factory attachment points using the provided M8 flanged hex nuts. Leave finger tight for now.
Step
6: Next, adjust the Hoop step level with the body of the cab and tighten all
hardware 30 ft. /lbs.
Step 7: Tighten all brackets at the main tube. ( 20-25 ft./lbs. torque ).
Step
8: Re-peat steps 2-7 for passenger side install.
12302 Shiloh Church Rd. Houston
TX 77066 Phone 281-880-6322 – Fax
281-880-6325
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>