n-FAB EXT22CC-TX Hoop Step Cab Length EPYX Step System Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
n-FAB EXT22CC-TX Hoop Step Cab Length EPYX Step System Instruction Manual
Components and Hardware
- Driver side step rail…………………………………………………………………(1)
- Passenger side step rail………………………………………………………….(1)
- Front bracket.. …………………………………………………………………………(2)
- Rear bracket………………………………………………………………………….(4)
- M8-1.25 x 30mm flanged cap screw w/washer…………………………(12)
- M10x12mm carriage bolt…………………………………………………………(12)
- M10 flanged hex nut……………………………………………………………….(12)
Tools for Installation
- 12mm socket
- 14mm socket
- Ratchet wrench
INSTALLATION
-
Install rocker panel brackets to the attachments points located on the backside of the channel using the supplied(#6) M10x12mm carriage bolts and (#7) M10 flanged nuts. Leave finger tight for now
-
Remove any factory hardware and discard.
-
Beginning with the (#1)driver side, carefully raise the step rail up and match the brackets with the factory mounting locations. Next, starting with the center bracket and using the supplied (#5) M8X30mm Hex cap with washer, start and leave loose.
-
Start the remaining hardware with the front and rear bracket and leave loose.
-
Next, adjust the step assembly up/down and front/back to level out the step rail with body panel and then tighten step to brackets at 20 ft. /lbs
-
After final adjustment, torque each bolt (#5, #7) to 17ft/lbs – 20 ft/lbs.
-
Repeat steps 2-6 with (#2) passenger side.
N-FAB® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST
1-800-449-6649
EMAIL: techsupport@n-fab.com
FOR WARRANTY INFORMATION VISIT: WWW.N-FAB.COM
References
- Fab | A Digital Asset Marketplace for Content Creators
- N-Fab Steps, Running Boards & Accessories | RealTruck
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>