n-FAB HWKT-00031X Components and Hardware Instruction Manual

n-FAB HWKT-00031X Components and Hardware

Product Information

The product is the RKR Step System for the 2022-23 Frontier CC (Crew Cab) truck. It is sold with part number N224RKRCC or N224RKRCCS4. The installation instructions can be found in the INST-02164 manual. The components and hardware for installation are included in the HWKT-00031X kit.

• Components and Hardware:
  1. Driver side step – 1 piece
  2. Passenger side step – 1 piece
  3. M8 Flanged hexnut – 12 pieces
  4. M8 flat washer – 12 pieces
  5. Detachable step (sold only with part number N224RKRCCS4) – 2 pieces
• Tools for Installation: Not specified.

Product Usage Instructions

Installation:

1. Step 1: Remove any OE (Original Equipment) step/running boards from the vehicle and discard them.
2. Step 2: Clean any undercoating or debris from the threaded studs.
3. Step 3: Place the driver side step (#1) on the studs and secure it with the supplied M8 flanged hex nut (#3) and M8 flat washer (#4). Loosely tighten them for now. Make sure the two slotted openings in the brackets slide and lock into place against the threaded stud before tightening.
4. Step 4: After final adjustment, fully tighten the brackets (x3) to the factory body mounts using a torque of 15-20 ft/lbs.
5. Step 5: Repeat the process with the passenger side step.

Detachable Step Installation (N224RKRCCS4):

1. Step 1: Attach the detachable step to the mounts located in between the RKR rails. Use the supplied 1.5 x 1 flanged hex bolts and 1.5 flanged hex nuts for securing. Note that the step will mount to the left side of the bracket, opposite of the weld.

Components and Hardware

Tools for Installation

• 13mm socket
• Ratchet wrench

INSTALL

• Step 1. Remove any OE step/running boards from the vehicle and discard.

• Step 2. Clean any undercoating or debris from the threaded studs.

• Step 3. Next, place (#1) Driver side step on the studs and secure with supplied (#3,#4) M8 flanged hex nut and M8 flat washer and loosely tighten for now.
  NOTE: B: Be se suurre te thhe te twwo so sllootttteed od oppeenniinnggs is in tn thhe be brraacckkeettss ssllidide ae annd ld loocck ik inntto po pllaacce ae aggaaiinnsst tt thhe te thhrreeaaddeed sd sttuud bd beeffoorree ttiighghtteenniinngg..

• Step 4. After final adjustment fully tighten (x3) brackets to the factory body mounts to (15-20 ft/lbs torque).

• Step 5. Repeat process with passenger side step.

PRT# JPTS32 Detachable Step Installation ( N224RKRCCS4)

Step 1. Attach step to mounts located in between the RKR rails using the supllied 1.5″ x 1″ Flanged hex bolts and 1.5″ flanged hex nuts.
Note: The step will mount to the left side of the bracket opposite of the weld.

References

• Fab | A Digital Asset Marketplace for Content Creators
• N-Fab Steps, Running Boards & Accessories | RealTruck

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>