n-FAB HWKT-04239X Podium Hoop Step Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HWKT-04239X Podium Hoop Step Instruction Manual
DO NOT USE IMPACT TOOLS
| Part | Description | Quantit y |
|---|---|---|
| HWKT-04239X | FHLB M10x25mm HEX FLANGED BOLT | 12 |
| 04240X | M10 CARRIAGE BOLT | 12 |
| M10 FLANGED HEX NUT | 12 | |
| Part | Quantity | |
| --- | --- | |
| Driver Side Step | 1 | |
| Passenger Side Step | 1 | |
| Mounting Bracket | 6 |
Step 1. Identify driver side step.
DRIVER
Step 2. Using the supplied M10 carriage bolt and nut, install the (x6) mounting brackets to each attachment point on the main tube and leave loose for now.
** NOTE: The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. ***
Step 3. Remove any factory running boards or hardware and discard.
Step 4.** Clean/tap the three factory threaded mounting locations.
Step 5. Carefully place step into place and loosely fasten using the
supplied M10X25mm hardware.
Step 6. Next, tighten the three lower bolts first following with the
three upper bolts.
Step 7. Finish by tightening the (x3) mounting brackets at the main tube.
Step 8. Repeat steps 3-7 for passenger side.
Step 9. Your install is now complete.
I-SHEET PART NUMBER: INST-00306
PART NUMBER: HPF2172B
PRODUCT: PODIUM HOOP STEP
APPLICATION: FORD BRONCO 4DR
12302 Shiloh Church Rd. Houston TX 77066 Phone
281-880-6322 – Fax
281-880-6325
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>