n-FAB HPF17105CC-6 Hoop Step Owner’s Manual

June 13, 2024
n-FAB

n-FAB HPF17105CC-6 Hoop Step Owner’s Manual
n-FAB HPF17105CC-6 Hoop Step

HARDWARE DESCRIPTION QTY.
8MM NYLOC NUT 20
8MM ZINC WASHER 22
8MM U NUT 2
8MM ZINC LOCK WASHER 2
8MM ZINC BOLT 1.25 X 25 2
M10X25mm Carriage bolt 16
M10 hex nut 16
PARTS INCLUDED QTY
--- ---
DRIVER SIDE STEP 1
PASSENGER SIDE STEP 1
Mounting bracket 8

DO NOT USE IMPACT TOOLS

Step 1. Locate the driver side step rail.
driver side step rail.
Step 2. Install the (x8) mounting brackets to each attachment point on the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave loose for now.
** NOTE: The brackets will attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the REAR of the step. *
mounting brackets

Step 3. If equipped, remove all 8mm nuts from the threaded studs and remove factory running board.

Step 4. Install the supplied 8mm u-nut clip in the upper body at the rear mounting location.

Step 5. Carefully raise step into position and align the three brackets with the threaded studs.
*NOTE: Be sure the front of the tube is in front of the plastic guard.
Carefully raise
Step 6. Starting with the rear bracket, push up towards the pinch weld so the 3” main tube is high and tight to the body of the vehicle and use the supplied M8 nut, m8 hex bolt and washers to secure the bottom stud first.

Step 7. Next, move to the front bracket and push up to level the main tube to body of the vehicle and secure all three mounts with the suppled M8 nut and washer. Do the same with the middle bracket and finish tighten the remaining nuts and bolt on the rear brackets.

Step 8. After finial adjustment, tighten all four brackets at the main tube.

Step 9. Repeat steps 2-8 with passenger side.

n-FAB Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals