n-FAB EXF212B-TX Rocker Panel Mounting Brackets Instruction Manual

June 13, 2024
n-FAB

n-FAB EXF212B-TX Rocker Panel Mounting Brackets

n-FAB-EXF212B-TX-Rocker-Panel-Mounting-Brackets-
product

Product Information

I-SHEET PART NUMBER: INST-00320

PART NUMBER: EXF212B-TX

PRODUCT: EPYX

APPLICATION: 21-C BRONCO 2DR

Parts Included

Part Quantity
Step Rail 2
Rocker Panel mounting Brackets 4

Hardware Description

Part Quantity
M10x25mm Hex flanged bolt 8
3/8 Flanged nuts 8

Product Usage Instructions

  1. Identify the Driver and Passenger side Step Rail.
  2. Note: A larger bracket will attach toward the front of step rail in the first position.
  3. Remove any factory running boards or hardware and discard them.
  4. Clean/tap the three factory-threaded mounting locations.
  5. Carefully place step into place and loosely fasten using the supplied M10X25mm hardware.
  6. Next, adjust the step assembly up/down and front/back to level out the step rail with body panel and then tighten step to brackets at 20 ft. /lbs.
  7. After final adjustment, tighten all rocker panel brackets to 30 ft./lbs.
  8. Repeat steps 3-8 for passenger side.
PARTS INCLUDED QTY
Step Rail 2
Rocker Panel mounting Brackets 4

n-FAB-EXF212B-TX-Rocker-Panel-Mounting-Brackets-fig-1

HARDWARE DESCRIPTION QTY.
HWKT-HWKT- 12095X
M10x25mm Hex flanged bolt 8
3/8” x ¾” carriage bolts 8
3/8” Flanged nuts 8

Step 1. Identify the Driver and Passenger side Step Rail. Identify the Driver and Passenger side Step Rail.

n-FAB-EXF212B-TX-Rocker-Panel-Mounting-Brackets-fig-2

Step 2 : Install three rocker panel brackets to the attachments points located on the backside of the channel using the supplied 3/8” x ¾” carriage bolts and 3/8” flanged nuts. Leave finger tight for now.

NOTE : Larger bracket will attach towards the front of step rail in the first position.

n-FAB-EXF212B-TX-Rocker-Panel-Mounting-Brackets-fig-4

STEP 3 : Remove any factory running boards or hardware and discard

STEP 4: Clean/tap the three factory threaded mounting locations.

STEP 5 : Carefully place step into place and loosely fasten using the supplied M10X25mm hardware.

Step 6 : Next, adjust the step assembly up/down and front/back to level out the step rail with body panel and then tighten step to brackets at 20 ft. /lbs.

Step 7 : Adjust the step rail to where you have approximately ¼” gap between the body of the vehicle and the top of the rail.

Step 8: After finial adjustment, tighten all rocker panel brackets to 30 ft./lbs. Step 9: Re-peat steps 3-8 for passenger side.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals