n-FAB NBC19CC-TX Running Board Installation Guide
- June 13, 2024
- n-FAB
Table of Contents
n-FAB NBC19CC-TX Running Board Installation Guide
| HWKT-09617X | 1 |
|---|---|
| BHCS- 09591X | M6X16MM BUTTON HEAD CAP SCREW |
| FW-09601 | M6 FLAT WASHER |
| BHCS-09603 | M6 flanged nut |
| CARB-09609 | 3/8″-16X1″ Gr 5 Steel Carriage Bolt 1000B BLACK ZINC |
| FLNT-00664 | 3/8-16 GRADE 8 STEEL FLANGE NUT, ZINKLAD 1000B |
| HWKT-03054X | QTY. |
| --- | --- |
| FLBW-00894X | M8-1.25 X 30MM CLASS 8.8FLANGE CAP SCREW W/WASHER |
| PARTS INCLUDED | QTY |
|---|---|
| Driver Side Running Board | 1 |
| Passenger Side Running Board | 1 |
| Rocker panel brackets | 6 |
| Step Plate | 4 |
Installation
Step 1: Identify Driver Side Nerf board.
Step2: Install the supplied step plate (x2) to each Running Board using
the M6x20mm button head bolts, M6 nuts and M6 flat washer.
** DO NOT OVER TIGHTEN **
Step 3: Install the supplied rocker panel brackets (x6) to the
attachments points located on the backside of the main tube (Driver/Passg)
using the supplied 3/8” x 1” carriage bolts and 3/8” flanged nuts. Leave
finger tight for now.
NOTE: BE SURE THE BEND DIRECTION OF EACH BRACKET IS CORRECT ON THE DRIVER
AND PASSENGER Nerf Board.
Step 4: Remove factory-running bards (Both sides) if equipped and
discard. You will see the 8mm threaded mounts in the body.
Step 5: Carefully raise the Nerf Board assembly up into position aligning
the mounting brackets with the factory-threaded holes. Beginning with the
center bracket start one of the supplied M8x30mm Hex bolts in the upper mount
and finger tighten. This will allow the step to suspend while you start the
reminder of the hardware.
Step 6: Next, start all remainder hardware in the factory locations and
leave loose.
Step 7: After final adjustment, tighten all the lower mounts first then
the upper mounts.
Step 8: There will be ½” of adjustment in the (x3) mounting bracket.
Adjust to desired position and tighten to (20 ft,/lbs).
Step 9: Repeat steps 5-8 for the passenger side.
I-SHEET PART NUMBER: INST-00236
PART NUMBER: NBC19CC-TX
PRODUCT: RUNNING BOARD
APPLICATION: 19-21 CHEVY/GM 1500 CC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>