n-FAB HPF1585CC Hoop Step Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HPF1585CC Hoop Step
HARDWARE DESCRIPTION
HARDWARE DESCRIPTION | QTY. |
---|
HWKT-00031X
FLNT- 00696X| M8 FLANGED HEX NUT| 18
FDRW-
00736X
| M8 FENDER WASHER ZINKLAD
1000B
| 18
| M10X25mm Carriage bolt| 12
| M10 hex nut| 12
PARTS INCLUDED
PARTS INCLUDED | QTY |
---|---|
DRIVER SIDE | 1 |
PASSENGER SIDE | 1 |
Mounting bracket | 6 |
INSTALLATION INSTRUCTIONS
Step 1. Locate the driver side step rail.
Step 2. Install the (x6) mounting brackets to each attachment point on the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave loose for now. ** NOTE: The brackets will attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the REAR of the step. *****
Step 3. If equipped, remove all 8mm nuts from the threaded studs and remove factory running board.
Step 4. Carefully raise step into position and align the three brackets
with the threaded studs.
*NOTE: Be sure the front of the tube is in front of the plastic guard.
Step 5. Starting with the rear bracket, push up towards the pinch weld so
the 3” main tube is high and tight to the body of the vehicle and use the
supplied M8 nut and washer to secure the bottom left stud first.
Step 6. Next, move to the front bracket and push up to level the main
tube to body of the vehicle and secure all three mounts with the suppled M8
nut and washer. Do the same with the middle bracket and finish tighten the
remaining nuts on the rear bracket.
Step 7. After finial adjustment, tighten all three brackets at the main tube.
Step 8. Repeat steps 2-7 with passenger side.
I-SHEET NUMBER: INST-00250
PART NUMBER: HPF1585CC
PRODUCT: HOOP STEP
APPLICATION: FORD F150 CC QC
CUSTOMERS SUPPORT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>