Kimberly-Clark KCI58754 Automatic Soap and Sanitizer Dispenser Optional Adhesive Installation Guide
- June 3, 2024
- Kimberly-Clark
Table of Contents
Kimberly-Clark KCI58754 Automatic Soap and Sanitizer Dispenser Optional Adhesive
interdiction
-
Open and remove bracket.
Ensure that bottom edge of bracket is a minimum 15 9⁄16”” (396mm) above any surface.
Tape is recommended for mounting on mirrored and polished/gloss tiled surfaces only. Do not use on rough, textured or stone surfaces. -
Thoroughly clean the surface the dispenser will mount to. Wait until completely dry.
Remove the backing from the adhesive strip and firmly press mounting bracket to wall surface for 1 minute. -
Wait a minimum 24 hours for the adhesive to fully cure prior to attaching dispenser housing and loading soap or sanitizer cartridge.
Installation using adhesive is not recommended and does not meet the requirements for fixed appliances of Household and Similar Electric Appliances Safety UL 60335-1, EN 60335-1, and IEC 60335-1. Such installation is done at your own risk and the warranty does not cover any damage arising from adhesive installation. To the extent allowed, Kimberly-Clark is not responsible for any damage to property and personal injuries arising from adhesive installation.
®/* Trademarks of Kimberly-Clark Worldwide, Inc.
© 2021 KCWW • www.kcprofessional.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>