Kimberly-Clark 09746 Omni Roll Hard Roll Towel Dispenser Installation Guide
- August 16, 2024
- Kimberly-Clark
Table of Contents
Kimberly-Clark 09746 Omni Roll Hard Roll Towel Dispenser
INSTALLATION GUIDE
Product Codes: 09746 Black
KIMBERLY-CLARK PROFESSIONAL™ OMNI ROLL HARD ROLL TOWEL DISPENSER
INSTALLATION
Tools Required:
For available spare parts contact your sales representative.
IMPORTANT! For secure mounting, follow these instructions thoroughly. Ensure that the proper mounting hardware is used for the appropriate wall type.
1. Mount the dispenser with the bottom edge at the desired height using a
minimum of 4 screws, usually 48” inches above the floor or 12” above the
counter (Figure 1). Please refer to local ADA guidelines for final placement.
2. Use all mounting screws provided in hardware packet as a minimum to attach
dispenser to wall (Figure 1).
Loading Instructions
1. Twist lever or use optional key to open dispenser (Figure 1).
2. Load roll onto arms with tail coming from the backside (Figure 2).
3. Close dispenser and ensure tail is accessible through opening (Figure 3).
Optional Key*
*Key (770251) enclosed in hardware packet.
1. Open cover of dispenser.
2. Remove pin from latch button shaft (Figure 1).
3. Pull latch button out and save for future use (Figure 2).
4. Use key to open dispenser (Figure 3).
*AMERICANS WITH DISABILITIES ACT (For use In U.S. only): Title 111 of the Americans with Disabilities Act (“ADA”) governs, in detail, the placement and operation of dispensers. You should ensure that your mounting and use of dispensers complies with that law as well as the regulations issued under that statue. The mounting suggestions in this document may or may not fulfill the obligations of the ADA with respect to your facility.
KIMBERLY-CLARK CORPORATION DISCLAIMS LIABILITY FOR PERSONAL INJURIES OR PROPERTY DAMAGES RESULTING FROM INSTALLATION NOT PERFORMED BY KIMBERLY- CLARK.
@/™Trademarks if Kimberly-Clark Worldwide, Inc. or its affiliates ®KCWW is a Registered Trademark of Kimberly-Clark Tissue Company. ®1998 KCC. All Rights Reserved. Manufactured for: Kimberly-Clark Corporation, Roswell GA 30076.
FAQ
Q: Can I use this dispenser in a commercial restroom?
A: Yes, this dispenser is suitable for commercial use and can be mounted securely in restrooms or other facilities.
Q: How do I know if I’m using the correct drill bit for the anchor size?
A: Refer to the installation instructions and ensure that the drill bit matches the anchor size specified for secure mounting.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>