Kimberly-Clark 09765 Lev-R-Matic Roll Towel Dispenser Owner’s Manual
- August 25, 2024
- Kimberly-Clark
Table of Contents
09765 Lev-R-Matic Roll Towel Dispenser
LEV-R-MATIC® ROLL TOWEL DISPENSER
DISTRIBUTRICE D’ESSUIE-MAINS LEV-R-MATIC®
Product Codes 09765 Black
Installation
` For secure mounting, follow these
instructions thoroughly. Ensure that the proper
mounting hardware is used for the appropriate
wall type.
1. Mount dispenser with bottom edge of the
housing approximately 48” from floor. Use at
least four pan head screws no smaller than #8
x 1.0 inch (Figure 1).
NOTE: Lever-stop feature must be installed
prior to mounting dispenser on the wall.
INSTALLATION
IMPORTANT! For secure mounting, follow these
instructions thoroughly. Ensure that the proper
LEVER-STOP FEATURES
Note: Install lever stop BEFORE mounting dispenser on wall.
1. On the back of the dispenser-housing, there are two molded lever-stops which can be used to reduce the sheet length per lever stroke
(Figures 2 & 3).
• Without the lever-stop, each push provides a 5.5” (140 mm) sheet.
• With the 5” lever-stop, each push provides approximately a 5” (12.70 cm) sheet.
• With the 4” lever-stop, each push provides 3.
approximately a 4” (10.16 cm) sheet.
Loading Instructions
1. Insert the key into the lock opening and rotate clockwise until the cover “pops” open (Figure 1).
2. Grip the cover and proceed to rotate the cover to its fully opened position where the detents lock into position.
3. Push a roll of product into the roll holders and release when the core becomes engaged (Figure 2).
4. Drape the paper over the black rubber roller and close the cover firmly until it locks (Figure 3).
5. Begin dispensing.
STUB ROLL OPERATING INSTRUCTIONS
6. When the main roll diameter is at or smaller than the left arm profile, remove by pushing it into the dispenser and locking it into the lower roll holders (Figure 4).
7. Drape the paper over the black rubber roller.
8. Proceed to load the main roll as previously described (Figure 5).
INSTRUCTIONS POUR LE CHARGEMENT
INSTRUCTIONS POUR LE ROULEAU DE REMPLACEMENT
*AMERICANS WITH DISABILITIES ACT (For use In U.S. only): Title 111 of the Americans with Disabilities Act (“ADA”) governs, in detail, the placement and operation of dispensers. You should ensure that your mounting and use of dispensers complies with that law as well as the regulations issued under that statue. The mounting suggestions in this document may or may not fulfill the obligations of the ADA with respect to your facility.
KIMBERLY-CLARK CORPORATION DISCLAIMS LIABILITY FOR PERSONAL INJURIES OR PROPERTY DAMAGES RESULTING FROM INSTALLATION NOT PERFORMED BY KIMBERLY-CLARK.
®/™Trademarks if Kimberly-Clark Worldwide, Inc. or its affiliates ®KCWW is a Registered Trademark of Kimberly-Clark Tissue Company. ®1998 KCC. All Rights Reserved. Manufactured for: Kimberly-Clark Corporation, Roswell GA 30076.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>