Kimberly-Clark 09603 Dispenser Bracket Instructions
- August 13, 2024
- Kimberly-Clark
Table of Contents
Kimberly-Clark 09603 Dispenser Bracket Instructions
Installation
Enclosed
Tools Required:
For available spare parts contact your sales representative.
IMPORTANT! For secure mounting, follow instructions thoroughly. Ensure that proper mounting hardware is used for appropriate wall composition, as enclosed hardware may not be compatible with your wall surface.
-
Locate the mounting bracket and screws in the hardware packet provided ( Figure 1a ). Using a level, position the bracket approximately 36” from floor and 7-9” from front edge of toilet to center of bracket and use as a template to mark holes for screws. Screw mounting bracket into the wall, using marked holes as a guide ( Figure 1b ).
-
Position dispenser over bracket, aligning recesses on back of dispenser over the 2 tabs protruding at top of bracket. Push down firmly to make sure the dispenser is fully seated on the bracket ( Figure 2 ).
-
Using the bottom holes as a guide, mark the location of the bottom mounting holes. Pre-drill the bottom 2 holes using a #25 drill (0.150” diameter).
-
Attach bottom of dispenser to the wall, installing screws through the molded-in holes at bottom left and right corners of dispenser back ( Figure 3 ).
NOTE: Use same quantity of mounting screws as provided in hardware packet as a minimum to attach dispenser to wall.
Loading Instructions
EMPTY DISPENSER (Both sides empty):
- Insert new roll in left position so that paper unrolls in clockwise direction ( Figure 1 ). Push up firmly until it locks into position securely.
- Allow approximately 3 inches of leading edge of paper to extend below the bottom of the dispenser.
DISPENSER WITH PARTIAL ROLL ON LEFT SIDE (Right side empty):
When the edge of roll can no longer be seen through window, it is small enough to transfer.
-
To remove partial roll push up and to the side and pull out. Flip roll so that paper unrolls in counter clockwise direction and install in the right position ( Figure 2 ).
-
Install new roll in left position according to steps 1 and 2 for EMPTY DISPENSER above ( Figure 3 ). Rewind leading edge of full roll so no paper is showing.
⁕ AMERICANS WITH DISABILITIES ACT ( For use In U.S. only): Title 111 of the Americans with Disabilities Act (“ADA”) governs, in detail, the placement and operation of dispensers. You should ensure that your mounting and use of dispensers complies with that law as well as the regulations issued under that statue. The mounting suggestions in this document may or may not fulfill the obligations of the ADA with respect to your facility.
KIMBERLY-CLARK CORPORATION DISCLAIMS LIABILITY FOR PERSONAL INJURIES OR PROPERTY DAMAGES RESULTING FROM INSTALLATION NOT PERFORMED BY KIMBERLY-CLARK.
®/™Trademarks if Kimberly-Clark Worldwide, Inc. or its affiliates ®KCWW is a Registered Trademark of Kimberly-Clark Tissue Company. ®1998 KCC. All Rights Reserved. Manufactured for: Kimberly-Clark Corporation, Roswell GA 30076.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>