Kimberly-Clark 09506 Dispenser Bracket Instruction Manual
- August 7, 2024
- Kimberly-Clark
Table of Contents
Kimberly-Clark 09506 Dispenser Bracket Instruction Manual
*Check for ADA regional & local installing/mounting requirements.
Installation
Enclosed
-
x4
-
x4
-
x1
Tools Required:
-
-
-
- Use correct drill bit for anchor size
-
-
IMPORTANT! For secure mounting, follow these instructions thoroughly. Ensure that the proper mounting hardware is used for the appropriate wall type.
-
Open dispenser. Keys and screws are included with each dispenser (Figure 1).
-
Mark wall such that lever is 48” from the floor so dispenser can be mounted directly above the toilet bowl.
-
With lever at proper level, place open dispenser back against wall and attach (Figure 2).
Note: use four screws to keep dispenser secure.
OPTIONAL PUSH BUTTON LOCK FEATURE
Dispenser comes with plug in place. To convert to push button operation:
-
Depress the end of the metal lock spring being careful not to over stress it. Remove the plug, if one is installed, by pushing on it from the inside (Figure 3).
-
Remove one of the push buttons from back panel of dispenser ( Figure 4 ).
-
Insert push button into hole from inside of dispenser. Insert metal lock spring back in place, lining up holes on it with posts on dispenser cover. Push bottom tab of lock spring up until it snaps into place **(Figure 5).
**
Loading Instructions
NOTE: Dispenser capacity is 2 seat cover packs.
-
Discard empty pack.
-
Insert new packet by hanging on hooks at top (Figure 1).
-
Close door of dispenser firmly
*AMERICANS WITH DISABILITIES ACT (For use In U.S. only): Title 111 of the Americans with Disabilities Act (“ADA”) governs, in detail, the placement and operation of dispensers. You should ensure that your mounting and use of dispensers complies with that law as well as the regulations issued under that statue. The mounting suggestions in this document may or may not fulfil the obligations of the ADA with respect to your facility.
KIMBERLY-CLARK CORPORATION DISCLAIMS LIABILITY FOR PERSONAL INJURIES OR PROPERTY DAMAGES RESULTING FROM INSTALLATION NOT PERFORMED BY KIMBERLY-CLARK.
®/™Trademarks if Kimberly-Clark Worldwide, Inc. or its affiliates ®KCWW is a
Registered Trademark of Kimberly-Clark Tissue Company. ®1998 KCC.
All Rights Reserved. Manufactured for: Kimberly-Clark Corporation, Roswell GA
30076.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>