ROBUS RAM40403012-01 Atmos 38w LED Panel Instruction Manual
- June 6, 2024
- ROBUS
Table of Contents
ATMOS 38W LED PANEL, 300X1200MM, 4000K, WHITE
RAM40403012-01
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR
FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in
any doubt about the installation or use of this product, consult a competent
electrician
Note:
Product technical information and specification may change over time
without prior notification. For the latest technical information please visit
our web site www.robus.com or
robusdirect.com
-20°C < Ta < +40°C, 220-240V ~ 50/60Hz, Class II, IP20
Luminaire is non-dimmable
Suitable for mounting on a normally flammable surface.
Driver must never be “hot-plugged” or connected to the fitting when live.
Doing this may damage the fitting and will void the warranty.
Installation
- Ensure mains supply is switched off before commencing work.
- Remove 300 x 1200mm tile from ceiling.
- Ensure the area above the fitting is free from obstacle pipes cable tray etc.
- Connect Brown wire (live) to L and Blue wire (neutral) to N to AC supply
- Ensure the connections going to and from the driver are secure.
- Place connector, drivers and cable into the ceiling void.
- Offer luminaire up to the ceiling void and manoeuvre into final position similar to standard ceiling tile.
Market Surveillance:
LS Code of energy efficiency Class E.
RAM40403012-LS
Disconnect LED panel. Remove screws, back plate and LEDs (LS)
Information for the Product user:
- Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with crossed out wheelie bin symbol).
- Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection centre for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.
- This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain
- The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household waste, but should be disposed of according to local WEEE regulations
The Installation must be carried out by a qualified electrician
L.E.D lighting & Electrical Distribution Group UC
IRE: Nangor Road, Dublin 12, D12 E7VP, Ireland
UK: Bracknell Enterprise & Innovation Hub, Ocean House, 12th Floor, The Ring,
Bracknell, Berkshire RG12 1AX, UK
Tel: +353 1 7099000
Fax: +353 1 7099060
Email: info@robus.com
Website: www.robus.com