ROBUS RDL30403012GUR-01 Dallas 30W LED Backlit Instruction Manual

June 5, 2024
ROBUS

ROBUS RDL30403012GUR-01 Dallas 30W LED Backlit

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician

Note:
Product technical information and specification may change over time without prior notification. For the latest technical information please visit our web site
www.robus.com.au and www. robusled.co.nz

-20°C < Ta < +40°C, 220-240V~50/60Hz, Class II, IP20
Driver is non-dimmable.
Suitable for mounting on a normally flammable surface.
Driver must never be “hot-plugged” or connected to the fitting when live. Doing this may damage the fitting and will void the warranty.

Installation

  1. Ensure mains supply is switched off before commencing work.
  2. Remove 1200 x 300mm tile from ceiling.
  3. Ensure the area above the fitting is free from obstacle pipes cable tray etc.
  4. Fix the metal plate onto the back of LED panel using the screws provided.
  5. Attach wire with clip to triangle hook and attach to solid ceiling structure so that when installed LED panel is secure.
  6. Connect plug to AC supply socket.
  7. Ensure the connections going to and from the driver are secure.
  8. Place connector, drivers and cable into the ceiling void.
  9. Offer luminaire up to the ceiling void and manoeuvre into final position similar to standard ceiling tile.

This product has no user serviceable parts. If any part is damaged, disconnect from mains and discontinue use.

ROBUS RDL30403012GUR-01 -Dallas -30W-LED-Backlit-fig 1 ROBUS RDL30403012GUR-01 -Dallas -30W-LED-Backlit-fig
2

Safety Instructions

Warning:
Luminaire marked as NON-IC according to ASNZS60598-2.2. Not suitable for use on residential properties.
DO NOT COVER OR ABUT. Any insulation material must be positioned at a minimum distance of 100 mm from the fitting.
Caution:
Recessed Luminaires may pose an increased risk of fire or property damage if not installed according to the instructions provided.

The Installation must be carried out by a qualified electrician

LED Group Australia Pty Limited Suite B, 2 Pittwin Road Capalaba
Queensland 4157
Australia

Tel: 07 3890 5444 Fax: 07 3890 4777

Email: purchases@robus.com Website: www.robus.com.au

LED Group
Crowe Hogwarth Tel: +64 3668 5285
72 Trafalgar Square Email: nz_purchases@robus.com NELSON 7010 Website: www.robusled.co.nz New Zealand

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ROBUS User Manuals

Related Manuals