ROBUS R235-13 Stainless Steel Outdoor GU GZ10 Wall Light Instruction Manual
- June 4, 2024
- ROBUS
Table of Contents
R235-13 Stainless Steel Outdoor GU GZ10 Wall Light
Instruction Manual
Specification:
Outdoor wall-mounted stainless steel (18%Ni, 10%Cr) fitting for GU10 or GZ10 cap lamps in steel finish
Electric shock protection: | Class 1 (Must be earthed!) |
---|---|
Lamp types: | max 240V 35W GU10/GZ10 cap |
Dimensions: | R235-13 |
Height | 150mm |
Projection | 120mm |
Weight: | 0.8Kg approx |
Body diameter | 62mm |
Ingress Protection: | IP44 |
Recommended Mounting: on a wall min 2.3m above ground level The minimum distance from the illuminated object is 50cm Complies with EN60598 (BS4533)
Installation:
Electrical products can cause death or injury, or damage to property. If in
any doubt about the installation or use of this product, consult a competent
electrician.
Ensure that mains supply is off before commencing work
- Remove the plastic base from the fitting by opening the domed nuts.
- Fix the plastic base securely to the wall
- Connect supply cables to terminals block, Brown (live) to L, Blue (neutral) to N, and Green/yellow to Earth. Seal cable entry with sealant and reattach fitting to the base, tightening the nuts securely to ensure the base is watertight
- Unscrew the body & insert the 35W lamp. Replace securely to avoid water ingress
Attention: Fitting becomes hot quickly. Switch off and allow to cool
before servicing Stainless Steel Fittings – Maintenance Instructions
This stainless steel product has been given a transparent oven-baked glaze
that provides extra protection against atmospheric agents. Despite this,
blotches may appear on the surface of the stainless steel. They can be removed
by a soft cloth soaked with neutral oil (WD-40 or equivalent).
Note: – If the product is exposed to very corrosive environmental
conditions (sea fronts, salty atmospheres, etc) it will require additional
maintenance.
Before installation, the stainless steel parts must be treated with a neutral
oil, which must penetrate all the joints. After treatment, dry with a soft
cloth. In very corrosive environments, the treatment with oil must be repeated
at least 4 times a year. In cases of serious corrosion use an abrasive paste
(specifically designed for stainless steel or chrome) to remove the stain and
then apply the neutral oil again.
Installation diagram:
Information for the Product user
- Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with crossed out wheelie bin symbol).
- Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection centre for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.
- This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain.
- The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household waste, but should be disposed of according to local WEEE regulations
The Installation must be carried out by an electrician
LED Group
Western Retail Park
Nangor Road
Dublin 12
Ireland
Tel: +353 1 7099000
Fax: +353 1 7099060
Email: info@led.ie
Website: www.led.ie
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>