ROBUS RDL50406012UGR-01 50W LED Backlit Panel Instruction Manual
- June 5, 2024
- ROBUS
Table of Contents
RDL50406012UGR-01 50W LED Backlit Panel
Instruction Manual
DALLAS 50W LED BACKLIT, 4000K, 600X1200MM,
LOW FLICKER, WHITE, C/W SEISMIC STRAP, FLEX, AND PLUG
RDL50406012UGR-01
PLEASE READ THE INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN THEM
FOR FUTURE REFERENCE.
! Electrical products can cause death or injury, or damage to property. If in
any doubt about the installation or use of this product, consult a competent
electrician
Note:
Product technical information and specification may change over time without
prior notification. For the latest technical information please visit our web
site www.robus.com.au and
www.robusled.co.nz
-20°C < Ta < +40°C, 220-240V~50/60Hz, Class II, IP20 Driver is non-dimmable.
Suitable for mounting on a normally flammable surface.
Driver must never be “hot-plugged” or connected to the fitting when live.
Doing this may damage the fitting and will void the warranty.
Installation
- Ensure the mains supply is switched off before commencing work.
- Remove 600 x 1200mm tile from the ceiling.
- Ensure the area above the fitting is free from obstacles pipes cable tray etc.
- Fix the metal plate onto the back of the LED panel using the screws provided.
- Attach wire with clip to triangle hook and attach to solid ceiling structure so that when installed LED panel is secure.
- Connect the plug to AC supply socket.
- Ensure the connections going to and from the driver are secure.
- Place connector, drivers, and cable into the ceiling void.
- Offer luminaire up to the ceiling void and maneuver into a final position similar to standard ceiling tile.
This product has no user-serviceable parts. If any part is damaged, disconnect from mains and discontinue use.
Safety Instructions:
Warning:
Luminaire is marked as NON-IC according to ASNZS60598-2.2. Not suitable for
use on residential properties.
DO NOT COVER OR ABUT. Any insulation material must be positioned at a minimum
distance of 100 mm from the fitting.
Caution:
Recessed Luminaires may pose an increased risk of fire or property damage if
not installed according to the instructions provided.
The Installation must be carried out by a qualified electrician
LED Group Australia Pty Limited
Suite B, 2 Pittwin Road
Capalaba
Queensland 4157 Australia
Tel: 07 3890 5444
Fax: 07 3890 4777
Email: purchases@robus.com
Website: www.robus.com.au
LED Group
Crowe Horwath
72 Trafalgar Square
NELSON 7010
New Zealand
Tel: +64 3668 5285
Email: nz_purchases@robus.com
Website: www.robusled.co.nz
References
- ROBUS: Home to Best-in-Class LED Lighting and Customisation | ROBUS
- ROBUS: Home to Best-in-Class LED Lighting and Customisation | ROBUS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>