ROBUS R201SCN-01 ZAK GU10 Mains Voltage Die Cast Aluminium Downlight User Manual
- June 4, 2024
- ROBUS
Table of Contents
ROBUS R201SCN-01 ZAK GU10 Mains Voltage Die Cast Aluminium Downlight
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent electrician
Note:
Product technical information and specification may change over time without
prior notification. For the latest technical information please visit our web
site www.ledgrouprobus.com or
robusdirect.com
-20°C < Ta < +40°C, 220-240V ~ 50/60Hz, Class II, IP20, Suitable for mounting on a normally flammable surface. Max Lamp: 50W GU/GZ10 lamp
Installation
- Ensure mains supply is switched off
- Mark ceiling with appropriate cut-out size
- Before cutting, ensure that the hole does not impinge on joists, pipe work,cables or other building services
- Ensure there is at least 100mm of free space around and 50mm above the luminaire. Do not cover the luminaire with thermal insulation
- Connect supply cables Live and Neutral to fitting terminals (polarity is unimportant). Do Not Earth
- Fit springs and offer luminaire up to cut-out with the longer leg of each spring being held vertically. The luminaire is retained in position by the spring tension between the short and the long leg of each spring against the ceiling
- Lamp installation and replacement.
Ensure mains supply is off. !When operating the luminaire is too hot to touch. Switch off and allow to cool before undertaking any maintenance work.
R201SC & R208SC: twist bezel inner ring anticlockwise to unlock, unclip the
lamp from the retaining spring at the back of the ring, hold lamp holder
firmly and rotate lamp 1/8 turn anti-clockwise to remove, clockwise to insert.
Luminaires and transformer not suitable for covering with thermally insulating
materia
Note: Bulb not included
Information for the Product user
- Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with crossed out wheelie bin symbol).
- Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection centre for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.
- This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain
- The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household waste, but should be disposed of according to local WEEE regulations
The Installation must be carried out by a qualified electrician
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>