Allremote Wireless Technology 220SG Series Motorized Remote Control Searchlight User Guide

June 6, 2024
Allremote Wireless Technology

Allremote Wireless Technology
220SG Series Motorized Remote Control Searchlight
User Guide

FCC INFORMATION

The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

  1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
  2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.

PACKING INCLUDED :

  • Model 220SG LED Searchlight

  • Handheld Wireless Remote Controller
    TX-SL017

  • Dash-mount Wireless Remote Controller
    TX-SL019

INSTALLATION ON

Unit: mm
Screw Hole:9.05
Allremote Wireless Technology 220SG Series Motorized Remote Control
Searchlight - INSTALLATION

FEATURES:

LED lighting
360° Unlimited Rotation/135° Tilt
Programmable Handheld Wireless Remote Controller
UV Ray and Saltwater Resistant
Automatically return to home position when searchlight is turned off
***Important Notice: If searchlight DC power is cut off (wires disconnected from the battery or power supply switched off), after reconnected, make sure to turn on the searchlight, using wireless or wired remote to make a full 360 rotation, in order to reset the home position memory.
SPECIFICATION:
Housing Color: Black / White
Dimension:** Unit: mm

Allremote Wireless Technology 220SG Series Motorized Remote Control
Searchlight

LED module:
LED chips X 10PCS / Watts: 50W
Current consumption: 13.5V 3.3A (MAX) / 28V 1.5A (MAX)
Color Temperature: 5,700~6,000K
Beam Pattern : Spot
Luminous intensity: 460,000 Candelas
Beam distance: 1,356M
Aluminum Housing as Heat Sink
Polycarbonate lens
Power: DC 12V ~ 24V (Multi-voltage)
Weight: 1.9Kgs / 4.2 lbs (Permanent mount)

OPERATION:

Wireless Remote

Allremote Wireless Technology 220SG Series Motorized Remote Control
Searchlight - Wireless Remote

  1. Operation
    Press the on/off button to Switch on or off the searchlight.
    Operate directions of the light beam by pressing the direction buttons. Up = Down = Right = Left =

  2. Button Fn: Dual speed (Fast / Slow speed switch)

HANDHELD WIRELESS REMOTE PROGRAMMING PROCESS:

  1. Switch off DC Power or disconnect from battery.
  2. Make sure there is NO other transmitter operating at the same time.
  3. Switch on DC Power, within 5 seconds press the Remote up ▲ and down ▼button once simultaneously.
  4. Searchlight will flash to acknowledge the Remote, connection has been made.
  5. To program the second Remote (up to 4 remotes may be used with the searchlight, programming a fifth will replace the first), within five seconds after the first Remote programmed, press the second Remote up and down button or repeat step 1.

Allremote Wireless Technology 220SG Series Motorized Remote Control
Searchlight - PROGRAMMING PROCESS

RADIO FREQUENCY: 2.4GHz
Wireless Remote Battery: AAA*2pcs
Wireless Remote Operation Distance: 65M

Allremote Wireless Technology 220SG Series Motorized Remote Control
Searchlight - Joystick Installation

ME-03-0025 V.2021 Jul.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals