Westinghouse WHBL03K 1250W Digital Blender Instruction Manual
- June 6, 2024
- Westinghouse
Table of Contents
Westinghouse WHBL03K 1250W Digital Blender
WARNING
Keep hairs,hands,fingers and other body parts away from the the blender blades
whilst in operation.
-
Read all instructions carefully before using your new blender.
-
Always turn the power off at the power outlet before you remove or insert the power plug. Remove by grasping the plug – do not pull on the cord.
-
Touch jug handle, jug lid and LCD Display on ly as some surfaces may become warm whilst the blender is in use.
-
Do not operate the blender if:
-
the cord or plug is split, melted or damaged.
-
the blender has malfunctioned.
-
the blender has been damaged in any manner.
If any of the above incidents occur, return your blender to the nearest authorised service center for examination, repair or adjustment. -
This blender is not intended to be operated by means of an external timer or separate remote-control system.
-
Close supervision is necessary when any appliance is used by or near children.
-
Any appliance that has been dropped or damaged should not be used until examined by an authorised service center.
-
Do not permit the mains supply cord or plug to touch hot objects or allow the power cord to lay across the blender.
-
If the mains supply cord is damaged, it must be replaced by the manufacturer, its service agent or similar qualified person in order to avoid a hazard.
-
This appliance is deemed for use indoors only.
-
Never plug the appliance into the power outlet if the cutting blades are exposed. Blades should be housed within the jug.
-
Do not under any circumstances immerse the power cord, mains plug or blender body in water or any other liquid.
-
Do not at any time, insert hands or other body parts into the jug whilst in operation.
-
This blender can be used by children aged from 12 years old and above and by persons with reduced physical, sensory or metal capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the blender in a safe way and understand the hazards
ELECTRICAL REQUIREMENTS
POWER SUPPLY CORD
- Do not attempt to modify the power cord or plug in any way.
- A short power supply cord is provided to reduce the risk of the user becoming entangled in or tripping over a longer cord.
- If the power supply cord is too short, do not use an extension cord. Have a
NOTE: Neither Westinghouse nor the retailer can accept any liability for damage to the product or personal injury resulting due to failure to observe the electrical connection procedures.
INSTALLATION GUIDE
- Carefully unpack your electric blender.
- Carefully remove packaging around the blender and power cord. Do not remove warning labels.
- Wash Jug, Lid and accessories before use.
WARNING : Do not under any circumstances immerse the blender body, mains cord or mains plug in water or any other liquid.
PARTS AND FEATURES
- Feeding Cap.
- Jug lid.
- 2L jug.
- Connecting Shaft.
- LCD Display.
- Control Panel.
- Mixing Bar.
- Brush.
- Silicone Pad.
- Body
BLENDER ASSEMBLY & OPERATION
Before the initial use of this product, please clean the jug assembly thoroughly. See the section “Cleaning and Maintenance” for details
-
Place all food ingredients to be processed into the jug, close the lid and tighten the feeding cap clockwise.
IMPORTANT: The amount of food must not exceed the maximum scale specified on the jug. When making warm liquids, the amount of ingredients must not exceed the 1.5L line. Note: Do not blend HOT liquids (above 40°C). -
.Place the loaded jug onto the base. Check whether the jug is balanced and that there are no foreign objects between the jug and the base.
-
Connect the power plug to the mains outlet and switch on the outlet.
-
Press the Power key to activate the blender.
-
Select the desired function on the touch control panel.
-
.Press the Start key to activate the selected program.
-
Press the Power key to stop the machine at any time.
-
Pulse key:
(1) Max continuous working time is 1 Minute.
(2) Press this key to activate the blender pulse function. When activated, the blender will operate at maximum speed. Releasing the key will cease operation. -
Power/Stop key:
-
This button turns the blender on. The blender will remain on until the selected function ends, or this button is pressed again. This button also acts to ‘stop’ the blender.
-
When the blender has stopped but program lights remain on, pressing this button will power off the blender.
-
When the blender has stopped, if there is no activity for 2 minutes the blender will power off automatically.
-
After the processing is complete, a buzzer will sound and the blender will stop operating automatically.
Note: Do not open or remove the lid during operation.
Manual Operation:
Adjust the speed and blending time according to personal preference. (refer to the recipe and food recommendations for blending time and instructions for food materials.) -
Place all food materials into the jug. Check whether the jug is balanced and that there are no foreign objects between the jug and the base. Press the power button to turn the blender on.
-
Select the time according to your requirements by pressing the Time + / – keys (1).
Select the speed according to your requirements by pressing the Speed + / – keys (2). -
Press the Start key to being operation.
-
Upon completing the set program, the buzzer will sound and the blender will cease operation.
-
Press the Power key to stop the machine at any time.
FOOD RECOMENDATIONS
No.
| Program|
Food Recommendation
---|---|---
1
|
Vegetables/ Fruit
Time: 2mins
|
1. Suitable for vegetable and fruit smoothies/purees.
2. Cut vegetables or fruit into 1.5-2cm pieces.
3. Pour preferred liquid (water/milk etc) into the jug.
4. Add sugar or seasoning according to taste preference.
2
|
Nut milk Time: 4mins
|
1. Add fully cooked beans, nuts, dried or fresh fruit into the jug.
2. Pour preferred liquid (water/milk etc) into the jug.
3. Add sugar or honey according to taste preference.
1. Soak beans or nuts for 8-12 hours in milk.
2. Pour milk and beans/nuts solution into the jug.
3. Add sugar or honey according to taste preference.
3
|
Paste
Time: 2mins
|
1. Use fully cooked rice, corn, buckwheat, oatmeal.
2. Pour warm water or soup/broth solution into the jug.
3. Add sugar or salt according to taste preference.
4
|
Smoothies Time: 30sec
| 1. Use 200g of your preferred fruit.
2. Add 50ml water or milk and 200g ice.
5
|
Soup
Time: 5mins (Blend time)
|
1. Use fully cooked beans, vegetables etc and cut into pieces of less than 2cm.
2. Place ingredients into the jug together and blend.
3. Add salt or seasoning according to taste preference.
1. Cut fresh beans, vegetables etc into 2cm pieces.
2. Add ingredients and soup/stock mix into the jug and blend.
3. Pour soup mixture into a pot and simmer for 10 minutes.
4. Add salt or seasoning according to taste preference.
6
|
Milkshake Time: 70sec
|
1. Prepare 100g yogurt, one tablespoon of preferred jam and 100g icecream.
2. Place all ingredients into the jug and blend together.
3. Add sugar or honey according to taste preference.
Note:
1. For more info please refer to food recipes.
2. The blender motor is equipped with overheat protection device which will
stop operation automatically if the machine is overheated due to excessive
running time.
In the event of overheating and subsequent shutdown, please disconnect the
power cord from the mains supply and allow the blender to cool down the
machine for 15 minutes.
RECIPE RECOMMENDATIONS
Nut milk
Ingredients (Serves 4)
Peanuts: 250g
Cashews: 200g
Milk: 1500ml
Sugar: 30g
Steps:
1. Bake peanuts and cashews in the oven for 10-15 minutes at 180°C.
2. Place all ingredients into the jug and press the “Nut milk” key.
Carrot Honey Juice
Ingredients (Serves 2)
Carrot: 200g
Honey: 30ml
Milk: 50ml
Water: 300ml
Ice: 50g
Steps
1. Clean and cut carrots into 2cm pieces.
2. Place all ingredients into the jug and press the “Vegetable/Fruit” key.
Black Bean Paste
Ingredients (Serves 3-4)
Cooked Black Beans: 250g
Walnuts: 8 pieces
Warm Water: 600ml
Steps
1. Place all ingredients into the jug and press the “Paste” key.
Strawberry Milkshake
Ingredients (Serves 3-4)
Strawberries: 250g
Yogurt: 200ml
Honey: 30ml
Milk: 100ml
Steps
1. Clean and cut strawberries into 2cm pieces. (remove stem and leaves).
2. Place all ingredients into the jug and press the “Milkshake” key.
Mango & Bsanana Smoothie
Ingredients (Serves 3-4)
Mango: 1 piece (250-300g)
Banana: 1 piece (150g)
Orange Juice: 500ml
Ice: 50g
Steps
- Peel and cut mango into 2cm pieces. (remove stone).
- Peel and cut banana into 2cm pieces.
- Place all ingredients into the jug and press the “Smoothie” key.
CHOPPING GUIDE
FOOD MAXIMUM OPERATION TIME
Meat 2.5cm Cubes| 250g| 15 sec.
Herbs| 50g| 10 sec.
Nuts, Almonds| 150g| 15 sec.
Cheese 2.5cm Cubes| 100g| 10 sec.
Bread| 80g| 10 sec.
Onions Chopped into 1/4| 200g| 10 sec.
Biscuits| 150g| 10 sec.
Soft Fruit| 200g| 10 sec.
CLEANING AND CARE
- WARNING: Do not under any circumstances immerse the power cord, mains plug or blender body in water or any other liquid.
- WARNING: Do not attempt to clean the unit whilst it is still plugged into the electrical power outlet. Always unplug the unit before cleaning.
- Do not use harsh or abrasive cleaning agents. The outside surface may be wiped clean with a soft, damp cloth and dried thoroughly. If necessary, a mild dishwashing detergent may be applied to the cloth but not directly applied to the blender.
- Soaking the jug, lid, and lid cap accessories in water will assist in the removal of sticky or tough to remove substances. In most instances, running warm water over the accessories is sufficient to remove most substances.
- When washing, non-abrasive cloths and plastic bristle kitchen brushes may be used to remove stubborn food particles from the jug and accessories. Do not use abraisive cloths and cleaning materials as they will damage the surfaces.
- Ensure the blender and all accessories are dried thoroughly after cleaning.
- Store in a dry place away from steam and humidity where possible.
TROUBLESHOOTING
BEFORE CALLING FOR SERVICE
If the blender fails to operate:
- Check to make sure the blender is plugged in correctly and securely. If it is not, remove the plug from the outlet, wait 10 seconds and plug it back in securely.
- Check for a blown or tripped circuit breaker in your home. If these seem to be working correctly, test another appliance in the same outlet to ensure the outlet is working correctly.
IF NONE OF THE ABOVE SOLVES THE PROBLEM, DO NOT TRY TO ADJUST OR REPAIR THE BLENDER YOURSELF.
CUSTOMER SERVICE
In the event you believe your blender to be defective, please return it along with your sales receipt to the place of purchase for resolution.
For any enquiries, please call our service center on: Tel: 1300 883 109
TROUBLESHOOTING
Troubleshoot your problem by using the chart below. If the blender still does not operate correctly, it may be defective.\
LIMITED WARRANTY
IMPORTED AND DISTRIBUTED BY RVM AUSTRALIA PTY LTD.
11 Tamara Drive, Cockburn Central, WA 6164
MADE IN CHINA
© 2021 RVM AUSTRALIA PTY LTD. ALL RIGHTS RESERVED.
WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse
Electric Corporation.
Used under license by RVM AUSTRALIA PTY LTD. ALL RIGHTS RESERVED
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>