claber 90916 3 Wire Rain Sensor User Manual

June 4, 2024
claber

90916 3 Wire Rain Sensor
User Manual

INSTALLATION

The Rain Sensor avoids wasting water by suspending sprinkler start-up in the event of rain. Install the Rain Sensor in a position exposed to rainfall and out of sprinkler jets.

claber 90916 3 Wire Rain Sensor

DESCRIPTION


  1. Top cover,
  2. Internal floater,
  3. Container,
  4. Fastening bracket,
  5. Bracket fastening screws

HOW IT WORKS. In order for the sensor to operate correctly, position the floater inside the container with the special fins facing upwards and the orange base facing downwards. The top cover must be kept closed to prevent any foliage or impurities from entering the sensor which would compromise the Rain Sensor operation.
When the Rain Sensor container is full (at least 5 mm of rainfall), it sends a stop signal to the timer. Depending on the model, the timer stops the irrigation cycle in progress or the next cycles as programmed.

claber 90916 3 Wire Rain Sensor - operate correctly

INSTALLATION

 The sensor has three wires. Inside the sensor, these are connected to a changeover contact A (one contact is normally closed N.C. and the other is normally open N.A.) which is activated when there is 5 mm of rainfall.

INSTALLATION. The rainwater collected in the container lifts the internal float. When it reaches 5 mm of rainfall, a changeover contact is activated.
The normally open contact (N.A.) connected to one of the Meteolab or Meteopragma sensor inputs send information about the rainfall conditions.
Connect the N.A. contact (common + N.A. brown wire and green wire) to a Meteolab (or Meteopragma) sensor input.

claber 90916 3 Wire Rain Sensor - METEOPRAGMA INSTALLATION. The normally closed contact (N.C.) can be used to disconnect the electrical control circuit between Meteocometa, Aqua-Home 4-6-8 or Multipla. When it is sunny again, the water evaporates and the float drops down. Disconnect the solenoid-valve common wire connection and connect the 2 ends to the N.C. contact (common + N.C. brown wire and white wire).
When it is sunny again, the water evaporates and the float drops down. The timer restores the irrigation program set by the user.

claber 90916 3 Wire Rain Sensor - METEOCOMETA

For Rain Sensor (code): – 90916

Documents / Resources

| claber 90916 3 Wire Rain Sensor [pdf] User Manual
90916, 3 Wire Rain Sensor, Rain Sensor, 90916, Sensor
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals