Uplink Vista 10SE Dual Port Gigabit User Guide

June 1, 2024
Uplink

Uplink Vista 10SE Dual Port Gigabit User Guide

Uplink Vista 10SE Dual Port Gigabit User Guide

CAUTION:

  • It is advised that an experienced alarm installer programs the panel as further programming may be required to ensure proper performance and use of the full functionality.
  • Do not route any wiring over circuit board.
  • Full panel testing, and signal confirmation, must be completed by the installer.

NEW FEATURE: For 5530M Communicators, the status of the panel can be retrieved not only from the status PGM but now also from the Open/Close reports from the dialler.
IMPORTANT NOTE: The Open/Close reporting needs to be enabled during the initial pairing procedure

Wiring the 5530M communicators to Honeywell Vista 10S
Uplink Vista 10SE Dual Port Gigabit User Guide - Wiring the 5530M
communicators to Honeywell Vista 10SWiring and Programming Uplink Communicators to Honeywell Vista 10SE

Programming the Honeywell Vista 10SE Alarm Panel via the Keypad

Enable Contact ID reporting:

Uplink Vista 10SE Dual Port Gigabit User Guide - Enable Contact ID
reporting

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals