Uplink Interlogix Simon XT Wiring Cellular Communicators and Programming the Panel Instructions
- June 1, 2024
- Uplink
Table of Contents
- Uplink Interlogix Simon XT Wiring Cellular Communicators and Programming
- Wiring the 5530m communicators to Interlogix Simon XT
- Programming the Interlogix Simon XT Alarm Panel via the Keypad
- Product Information
- Product Usage Instructions
- FAQ
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Uplink Interlogix Simon XT Wiring Cellular Communicators and Programming
the Panel
CAUTION:
- It is advised that an experienced alarm installer programs the panel as further programming may be required to ensure proper performance and use of the full functionality.
- Do not route any wiring over the circuit board.
- Full panel testing, and signal confirmation, must be completed by the installer.
NEW FEATURE : For 5530M Communicators, the status of the panel can be
retrieved not only from the status PGM but now also from the Open/Close
reports from the dialler. Therefore, wiring the white wire and programming of
the status PGM of the panel is optional.
IMPORTANT NOTE: The Open/Close reporting needs to be enabled during the
initial pairing procedure.
Wiring the 5530m communicators to Interlogix Simon XT
Programming the Interlogix Simon XT Alarm Panel via the Keypad
Enable Contact ID reporting:
Product Information
Specifications
- Product: Interlogix Simon XT
- Compatibility: Works with 5530M and M2M communicators
- Features: Contact ID reporting, Open/Close reports integration
Product Usage Instructions
Wiring Uplink’s Cellular Communicators to Interlogix Simon XT
Ensure proper wiring of the communicators following the provided diagram.
Programming the Panel
- Access System Programming by pressing Down 3 times.
- Enter the default installer code 4321 and press OK.
- Set up Phone #1 by entering the phone number and saving it.
- Enable DTMF Dial by selecting ON and saving.
- Configure Opening and Closing Reports to ON.
- Select All CID for Reporting Communication Modes.
- Exit programming mode by following the prompts.
FAQ
Q: What is the default installer code for programming?
A: The default installer code is 4321.
Q: How do I enable Open/Close reporting?
A: Open/Close reporting can be enabled during the initial pairing
procedure. Ensure it is set up for proper functionality.
Q: Can I retrieve panel status from Open/Close reports?
A: Yes, with 5530M Communicators, panel status can be retrieved from
Open/Close reports in addition to the status PGM.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>