Armacost Lighting 813360 Wall Mount Power Supply with Terminal Connector Installation Guide
- June 10, 2024
- Armacost LIGHTING
Table of Contents
Armacost Lighting 813360 Wall Mount Power Supply with Terminal Connector
Installation Guide
Installation
Power must be disconnected at all times during installation. Observe polarity of the DC output. Failure to observe polarity could damage LED lighting. Total wattage of all LED fixtures used must not exceed the maximum watt rating of the power supply. These electronic LED power supplies are not compatible with standard 120-volt AC dimmer switches. Use only Armacost Lighting low voltage DC LED dimmers for brightness control of lighting.
- Full safety shut off protection in case of lighting overload, open circuit, short circuit, overtemperature or other fault. Unit will automatically restart after the fault has been corrected.
- Use only insulated staples or plastic ties to secure cords and wires.
- Route and secure wires so they will not be pinched or damaged.
- All wiring must be in accordance with national and local electrical codes, low voltage Class 2 circuit. For wire runs inside of walls, use properly certified CL2 or better cabling and appropriate mounting hardware. If you are unclear as to how to install and wire this product, contact a qualified electrician. Failure to install this device properly may result in electrical shock or fire.
- Do not install Class 2 low voltage wiring in the same runs as AC main power. If AC and low voltage wires cross, keep them at 90-degree angles.
SPECIFICATIONS
Input voltage: 100–120V
Input frequency: ~50/60Hz
Usage: Dry location only
Operating temperature: -5 to 95°F (-15 to 35°C)
3-YEAR LIMITED WARRANTY
Failure to use this power supply for its intended purpose or improper
installation will void warranty.
Questions? Email
support@armacostlighting.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>