Uplink 5530M Cellular Communicator and Programming the Panel Installation Guide

June 17, 2024
Uplink

Uplink 5530M Cellular Communicator and Programming the Panel Installation

Guide

DSC Impassa (SCW9055, SCW9057)

Wiring Uplink’s 5530M Cellular Communicator and Programming the Panel

CAUTION:

  • It is advised that an experienced alarm installer programs the panel as further programming may be required to ensure proper performance and use of the full functionality.
  • Do not route any wiring over circuit board.
  • Full panel testing, and signal confirmation, must be completed by the installer.

NEW FEATURE: For 5530M Communicators, the status of the panel can be retrieved not only from the status PGM but now also from the Open/Close reports from the dialler.

Wiring the white wire is necessary only if the Open/Close reporting is disabled.

IMPORTANT NOTE: The Open/Close reporting needs to be enabled during the initial pairing procedure.

Wiring the 5530M communicators to DSC Impassa

Wiring the 5530M communicators to DSC Impassa

Wiring the 5530M with UDM to DSC Impassa for remote upload/download

Wiring the 5530M with UDM to DSC Impassa for remote upload-
download

Programming the DSC Impassa Alarm Panel via the Keypad

Enable Contact ID reporting:

Enable Contact ID reporting

Program Keyswitch zone and output:

Program Keyswitch zone and output

Programming the DSC Impassa Alarm Panel via the Keypad for remote

Upload/Download (UDL)

Program the Panel for Upload/Download (UDL):

Program the Panel for Upload-Download UDL

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals