SYNCO G2(A2) 2-Person Digital Wireless Microphone User Manual
- June 4, 2024
- SYNCO
Table of Contents
Person Digital Wireless Microphone
User Manual
G2(A2) 2-Person Digital Wireless Microphone
Dear customer,
Thank you for purchasing our product. Please read the following instructions
carefully before first use and keep this user manual for future reference. Pay
particular attention to the safety instructions. If you have any questions or
comments about the device, please contact the customer line.
✉ www.alza.co.uk/kontakt
✆ +44 (0)203 514 4411
Importer Alza.cz a.s., Jankovcova 1522/53,170 00 Praha 7,
www.alza.cz
Caring For Your SYNCO Product
- Please keep the product in a dry, clean, dust-free environment.
- Keep corrosive chemicals, liquids, and heat sources away from the product to prevent mechanical damage.
- Use only a soft and dry cloth for cleaning the product.
- Malfunctions may be caused by dropping, the impact of external force.
- Do not attempt to disassemble the product. Doing so voids the warranty.
- Please have the product checked or repaired by authorized technicians if any malfunctions happened.
- Failure to follow all the instructions may result in mechanical damage
- Warranty does not apply to human errors.
Package list
Product Instruction
1. External Mic Input
2. USB-C Port
3. Power (MUTE)
4. Reset (Help with Eject Pin)
5. Low Cut| 6. Pairing
7. Built-in Mic
8. Display Screen
9. Pocket Clip
---|---
1. USB-C Port
2. Power (Mono/Stereo)
3. Reset (Help with Eject Pin)
4. Channel A Gain Control
5. Channel B Gain Control| 6. 3.5mm Audio Output
7. 3.5mm Monitoring Jack
8. Display Screen
9. Pocket Clip
---|---
Display Screen
Operations
-
Power/Mute
Long Press 2s: turn on/off the system
Short Press: mute/unmute the microphone -
Charging
5V/2A; with USB-C Charging Cable
Please fully charge the product before use. -
External Mic Input TRS Mic Only
(Note: When using an external mic, please insert it into the mic input properly.)
-
Mic Windshield & Device Installation
-
Low Cut
Short Press: 150Hz Low Cut On
Short Press again: Low Cut Off -
Pairing
The system will pair automatically after powering on.
(Note: Before successfully connecting, the transmitter channel will display A
by default. The TX connected to the receiver first is Channel A, and the one
connected later is Channel B.)
Manual pairing: long press the Channel A Gain Control and Channel B Gain
Control on the RX and pair on the TX for 3 seconds at the same time.
RX
-
Power/Mono/Stereo Switch
Long Press 2s: turn on/off the system
Short Press: Switch Mono/Stereo mode (Note: Stereo mode is unavailable in phone devices.) -
Charging
5V/2A; with USB-C Charging Cable
Please fully charge the product before use. -
Reset
-
Gain Control
0-5 Level (0 →3 →6 →9 →12 →15 →0)
Each press increases the gain of Channel A/Channel B by one level.
-
Pairing
Long press for 3s at the same time.
****
The system will pair automatically after power is on. Manual pairing: long
press the Channel A Gain Control and Channel B Gain Control on the RX and
Pairing on the TX for 3 seconds at the same time.
(Note: The first TX that successfully connects with the RX will be
Channel A.)
- Audio Monitoring & Output Connection
Setting The Recording Level Correctly
Camera devices generally have poor-quality, noisy preamps. In order to get the
cleanest signals possible, it is highly recommended that you set the recording
level on your camera quite low, 1/2 or 1/3 of it.
G2 provides variable gain control, allowing you to tailor your levels to just
about any environment and recording device.
Adjust the recording level of inbuilt mics for SONY Camera (Take A7S II for
example)
Adjust the recording level of inbuilt mics for Canon Camera (Take EOS 5D Mark IV for example)
Adjust the recording level of inbuilt mics for Canon Camera (Take EOS 5D Mark for example)
Specifications
TX Transmitter
Wireless Transmission | Digital 2.4GHz |
---|---|
RF Frequency Band | 2400-2483.5MHz |
Frequency Response | 20Hz-20KHz |
Working Distance | 492ft/150m (LOS area), 164ft/50m |
Mounting | Pocket Clip |
Audio Input | 1/8” /3.5mm TRS Mic Input |
Audio Input Level | 1V (0dBV) |
Power Requirements | 3.3V-4.7V |
Battery Type | Built-in Lithium Battery, 500mAh |
Battery Charging Time | 1.5H |
Battery Life | 8H |
Display | TFT Screen |
Dimensions | 52x42x17mm |
Material | Plastic |
Weight | 39g |
RX Receiver
Wireless Transmission | Digital 2.4GHz |
---|---|
RF Frequency Band | 2400-2483.5MH |
Approximate RF Sensitivity | -81dBm |
Working Distance | 492ft/150m (LOS area), 164ft/50m |
Mounting | Pocket Clip |
Number of Audio Channels | 2 |
Audio Output | 1/8” /3.5mm TRS Mic Input |
Gain | 0-5 Level |
Audio Output Level | Line Out: 1V; Monitoring: 25-30mW |
Power Requirements | 3.3V-4.7V |
Battery Type | Built-in Lithium Battery, 500mAh |
Battery Charging Time | 1.5H |
Battery Life | 8H |
Display | TFT Screen |
Dimensions | 52x42x17mm |
Material | Plastic |
Weight | 39g |
Microphone
Form Factor | Built-in/External Mic |
---|---|
Sound Field | Mono |
Polar Pattern | Omnidirectional |
Frequency Range | 50Hz-20KHz |
Sensitivity | -40dB (±3dBm re 1V/Pa at 1K |
Maximum SPL | 135dB SPL (at 1KHz) |
Warranty Conditions
A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you need repair or other services during the warranty period, contact the product seller directly, you must provide the original proof of purchase with the date of purchase. The following are considered to be a conflict with the warranty conditions, for which the claimed claim may not be recognized:
- Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation and service of the product.
- Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g. during transport, cleaning by inappropriate means, etc.).
- Natural wear and aging of consumables or components during use (such as batteries, etc.).
- Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.
- If anyone has made modifications, modifications, alterations to the design or adaptations to change or extend the functions of the product compared to the purchased design or use of non-original components.
EU Declaration of Conformity
Identification data of the manufacturer:
Importer: Alza.cz a.s.
Registered office: Jankovcova 1522/53, Holešovice, 170 00 Prague 7
The subject of the declaration:
Title: Microphone
Model / Type: G2(A2)
The above product has been tested in accordance with the standard(s) used to
demonstrate compliance with the essential requirements laid down in the
Directive(s):
Directive No. (EU) 2014/53/EU
Directive No. 2011/65/EU as amended 2015/863/EU
Prague, 23.7 2020
WEEE
This product must not be disposed of as normal household waste in
accordance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE – 2012/19 / EU). Instead, it shall be returned to the place of purchase
or handed over to a public collection point for the recyclable waste. By
ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product.
Contact your local authority or the nearest collection point for further
details. Improper disposal of this type of waste may result in fines in
accordance with national regulations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>