KSE-Lights PML-200 LED Moon Room Lamp Instruction Manual

: June 13, 2024
: KSE-LIGHTS

Table of Contents

LED
- MANUAL
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED

MOON

KSE-Lights PML-200 LED Moon Room Lamp A0

MANUAL

ROOM LAMP

PML-200

LIGHT DIFFUSOR
LIGHT UNIT
SUPPLY LINE (230 V AC)
MOUNTING POINT
ON/OFF SWITCH

LED-MOON 200W
PML-200

26000 LUMENS 200 WATTS IP54 WITHOUT PLUG IP44 WITH PLUG

TRIPOD MOUNTING
Screw the pivot mount into the lamp housing and then place the lamp on the supplied tripod. Use the tripod only on a flat surface with sufficient space.

SCAFFOLD USE
Mount the hook from below into the housing of the lamp. The hook can now be mounted on tubes (such as from scaffolding).

MOUNTING WITH ROPE
The ring can be screwed into the lamp housing. Afterwards, you can hang the lamp from the ceiling with a steel cable or snap hook.

REPLACE DIFFUSOR
To replace the diffuser, first remove the screw on the top, then loosen the Velcro on the bottom and open the zipper. Carefully remove the old diffuser, replace it with the new one and carefully place it on the light unit. Now attach it to the previously loosened mounting points to ensure a secure and stable hold.

SAFETY INSTRUCTIONS

Before using the LED Moons for the first time, carefully read the operating instructions and keep them for future reference.
Before each use, inspect the fixture and accessories for any damage or defects. Do not use the fixture if it is damaged or not functioning properly. Ensure that the power cord and connector are in good condition and free of damage. Use only approved extension cords and make sure they are suitable for outdoor use.
Position the LED-Moon on a flat, stable and non-slip surface to prevent it from tipping over or slipping during operation.
Keep the LED-Moon away from water, moisture and flammable materials. Although the fixture is designed for outdoor use, it should be protected from extreme weather conditions such as heavy rain or snow.
Do not leave the fixture unattended during operation and ensure that children and pets are not in the immediate vicinity.
Do not touch the fixture or diffuser during operation as they may become hot. Wait until the fixture has cooled down completely before handling or transporting it.
Switch off the light and disconnect it from the power supply before changing the diffuser, performing maintenance or cleaning the unit.
Use only spare parts and accessories recommended by the manufacturer to ensure optimal function and safety of the LED Moons.
In the event of a malfunction or electrical problem, unplug the unit immediately and contact a professional or the manufacturer for further instructions.

AFTER SALES SERVICE

The warranty of this product is valid for two years after purchasing. The time of warranty starts with the date on purchase invoice. The warranty extends over material defects or dysfunctions that are not caused by improper use. In case of guarantee please fill out the customer service form full and return this together with lamp and a copy of the purchase invoice to the local distributor. The lamp will be repaired, or a replacement will be issued.
Secondary damage caused using the lamp with broken parts are not covered by the warranty.
In case of misuse, the warranty will be invalidated.
For the following conditions we will repair the product at appropriate charge:

Beyond the warranty time.
If lamp has been damaged by improper operation.
If lamp has been cracked or damaged by impact.
Secondary damages caused by the use with broken parts (such as broken housing or switch rubber)

WARNING

These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products should be installed in accordance with these instructions, current electrical codes, and/or the current National Electric Code (NEC).
To reduce the risk of fire, electric shock or injury to persons, make sure that the electrical power to the fixture is disconnected at the source prior to installation or any servicing.