KSE-LIGHTS KS-8810 Explosion Proof Hand Lamp User Manual
- October 30, 2023
- KSE-LIGHTS
Table of Contents
User manual for model KS-8810
Flashlight for use in hazardous locations
Important:
Read these instructions before use and maintain the flashlight for reference
Product:
KS-8810 Industrial Flashlight for use in hazardous locations.
Battery types:
Use only battery types below:
| Alkaline Type | NiMH Type |
|---|---|
| Energizer E91 | Energizer NH15-2300 |
| Duracell MN1500 | |
| Rayovac 815 | |
| Ansmann 5015548 | |
| Ansmann 1502-0002 |
Features:
- Intrinsically safe for use in hazardous locations
- Multiple functions: High / Low / Flash
- Cree LED
- IP67
- Double O-ring
- Tough and durable casing
- High Impact LENS
- Non-Slip Handle
- High-Visibility yellow colour body
- Safety Lock
Certifications:
| UL USA : UL FILE NO.: OERX.E324236
Class I Div 1&2 Grp ABCD Class II
Div 1&2 Grp EFG
Class III Temperature Code: T4
---|---
| IECEx Worldwide : IECEx CERTIFICATE NO.:
IECEx UL13.0060X
Ex ia IIC T4 Ga
| Ex Europe : ATEX CERTIFICATE NO.:
DEMKO 13 ATEX 1205039X
II 1G Ex ia IIC T4
| 2813
DAY SUN TECHNOLOGY LTD
Address: 1stFL, No.1, Alley 2, Lane 110, Sec.4, Hsimen Rd.
North District, Tainan, 704 Taiwan
Standards:
- UL 913 7th Edition, 2011-09.23
- CSA C22.2 No. 157-92, Reaffirmed 2013
- 60079-0 : 2009 Edition
- EN 60079-11 : 2007 Edition
- EN 60079-26 : 007 Edition
- IEC 60079-0, 5th Edition
- IEC 60079-11, 5th Edition
- IEC 60079-26, 2nd Edition
Installation:
Operation:
Lighting by pushing the switch of KS-8810, by turning it on for three multiple functions of Full Lighting / Half Lighting / Flashing and turn it off as well. This switch is operated by magnetism.
Safety Warnings:
- The screw shall be secured tightly after opening and closing of the enclosure.
- Substitution of components may impair intrinsic safety.
- Clean the flashlight only with damp cloth to avoid static electricity.
- Do not flash the light beam directly into human’s eyes.
- Always use this flashlight by following regular and legal rules governed by industrial control and management authority from every country.
Change of batteries:
Warning – Replace batteries only in non-hazardous areas.
Please unscrew the front cap, please do not directly touch inside heat sink
set, it might be a bit hot after long time using, remove the cap, remove the
reflector with LED inserted, avoiding touching inside surface of reflector, it
might affect the performance of lighting. Always use proper batteries to go
with KS-8810, do not use mixed brands. Always replace all batteries at the
same time, filling new batteries in corresponding to (+) positive and (-)
negative mark sticker inside of battery case by following rules to batteries:
- Use only battery type of Energizer E91 or Duracell MN1500 or Rayovac 815 or Ansmann 5015548 or Ansmann 1502-0002 or Energizer NH-15-2300.
- To reduce the risk of explosion do not mix used batteries with new batteries, or mix batteries from different manufacturers or from different types.
- Do not charge NiMH batteries in the flashlight. Charge the NiMH batteries according to the manufacturer‘s specification.
- Remove the batteries when unused for a period of time to prevent battery leakage in the device.
Warning: The screw should be secured tightly after replacing the batteries. Install the batteries in the correct assembly. When re-insert reflector set, with smart design, please gently insert it, it could slowly slide into groove and fit it well, please do not over-force on it. Closing the flashlight by screwing the cap right to end of the screw thread.
Declaration of Conformity
This declaration certifiies compliince with the indicaled directives but
implies on assurance of properlies.
The safety of the product nformabon should be observed.
The startment turns off aulomaticaly whenever chanyus are made in the product
thal lieve nol boon rmadched with the cumpany KSE LIGHTS GmbH.
KSL-LIGHTS GmbH
Thiingenfeid 8
58256 Linepetul
Germany| Tek -49 (0)2353-9824/ 3U
Fax; —49 (0)2333-98247 49
Www.kse-lights.com
Info@kse-lights.com| Bankverbind ung:
Sparkasse Fnnepetal – Breckerteld
IBAN:DL62 4545 1060 0000 0927 67
Swift/BIC; WELADEDTENE| GeschaftsfGhrer: Detlev Suel / Nikolai Seul
WFFF-Reg.-Nr.DF 270 590 5?
Reyistergericht Hugen HRB 7367
Ust-Id Nr: OE 814 691073
---|---|---|---
KSE-LIGHTS GmbH
Thüngenfeld 8, 58256 Ennepetal, Germany
Tel.: +49 2333 98247 30 • Mail:info@kse-lights.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>