BILT HARD GCB-1101 10 Inch No Flat Tires Poly Yard Dump Cart Installation Guide
- May 15, 2024
- BILT HARD
Table of Contents
BILT HARD GCB-1101 10 Inch No Flat Tires Poly Yard Dump Cart
MODEL# GCB-1101
Using tips: Video on YouTube
Our website: bilthardusa.com
IMPORTANT SAFETY INSTRUCTIONS
- Read, understand and follow ALL instructions before using this product.
- Do not exceed the overall maximum load capacity of 600 lbs. or the maximum dumping load capacity of 300Ibs.The weight rating is based on an evenly distributed load.
- Do not allow children to use the cart without supervision. This cart is not a toy.
- Do not use this cart for transporting passengers.
- This cart is not intended for highway use.
- Do not exceed 5 mph.
- Distribute the load evenly over the surface of the tray.
- Do not load items on the top edges of the tray.
- If any parts become damaged, broken or misplaced, do not use the cart until replacement parts have been obtained.
- Do not use the cart on surfaces or for transporting objects that can cause damage to the tires.
- It is recommended that the cart be inspected for damage before each use.
- KEEP THESE INSTRUCTIONS FOR FURTHER REFERENCE.
www.bilthardusa.com
Customer Support:
[email protected] /
888-680-2849
Parts
Hardware
-
Assemble the fitting tray bracket (B) and Tray (C) together with 8 sets of M8*20mm bolts. Note: Do not tighten the screws yet.
-
Assemble the fitting locking (G) tray bracket (B) and tray (C) together with 4 sets of M8*20mm bolts. Note: Tighten all screws in step 1 and Step 2 after assembly.
-
Assemble the fitting tray bracket (B) and folding bracket (A) together with a set of M8*45mm bolts.
-
Assemble the fitting Rear axle I and folding bracket (A) together with 2 sets of M10*65mm bolts.
-
Assemble the fitting front axle (H) and folding bracket (A) with 1 set of M12 nuts.
Note: Adjust the tightness of the nut according to the steering flexibility of the front axle bracket.
-
Assemble the fitting wheel (D) on top of the front axle (H) and rear axle I using 4sets M16mm and cotter pins.
-
Turn over the cart.
-
Assemble the handle (E) to the yoke (F) with a set of Ml6*60mm bolts.
