KSE-LIGHTS KS-9900 Industrial Flashlight User Manual
- October 30, 2023
- KSE-LIGHTS
Table of Contents
User manual for model KS-9900
KS-9900 Industrial Flashlight
Flashlight for use in hazardous locations
Important:
Read these instructions before use and maintain the flashlight for reference
Product:
KS-9900 Industrial Flashlight for use in hazardous locations.
Battery types:
Use only battery types below:
Alkaline Type
Energizer E92
Duracell MN2400
Rayovac AAA LR03
Panasonic AAA LR03
Features:
- Intrinsically safe for use in hazardous locations
- Functions: On / Off
- Cree LED
- IP67
- Tough and durable casing
- High Impact LENS
- Non-Slip Handle
- High-Visibility yellow colour body
Certifications:
| Class I Div 1 & 2 Grp ABCD
Class II Div 1 & 2 Grp EFG
Class III Temperature Code: T5 IP67
File number: E324236
---|---
| Gas: Ex ia IIC T5 Ga (zone 0)
Mine: Ex ia I Ma
IECEx UL 16.0015X
| Gas: II 1G Ex ia IIC T5 Ga (Zone 0)
Mine: I M1 Ex ia I Ma
DEMKO 16 ATEX 1661X
****| 2813
DAY SUN TECHNOLOGY LTD
Address: 1st FL, No.1, Alley 2, Lane 110, Sec.4, Hsimen Rd.
North District, Tainan, 704 Taiwan
Standards:
- UL 913 8th Edition
- CSA C22.2 No. 157-92, Reaffirmed 2012
- EN 60079-0 : 2012+A11 : 2013 Edition
- EN 60079-11 : 2012 Edition
- EN 50303 : 2000 Edition
- IEC 60079-0 : 6th Edition
- IEC 60079-11 : 6th Edition
Installation:
Operation:
Lighting by pushing the switch on the backside of the lamp. By pushing it again, the light is switched off.
Safety Warnings:
- The screw shall be secured tightly after opening and closing of the enclosure.
- Substitution of components may impair intrinsic safety.
- Clean the flashlight only with damp cloth to avoid static electricity.
- Do not flash the light beam directly into human’s eyes.
- Always use this flashlight by following regular and legal rules governed by industrial control and management authority from every country.
Change of batteries:
Warning – Replace batteries only in non-hazardous areas.
Please unscrew the front cap, please do not directly touch inside heat sink
set, it might be a bit hot after long time using, remove the cap, remove the
reflector with LED inserted, avoiding touching inside surface of reflector, it
might affect the performance of lighting. Always using proper batteries to go
with KS-9900, do not use mixed brands. Always replace all batteries at the
same time, filling new batteries in corresponding to (+) positive and (-)
negative mark sticker inside of battery case by two rules to batteries:
- Use only battery type of Energizer E92 or Duracell MN2400 or Rayovac AAA LR03 or Panasonic AAA LR03.
- To reduce the risk of explosion do not mix new batteries, or mix batteries from different manufacturers or from different types.
- Remove the batteries when unused for a period of time to prevent battery leakage in the device.
Warning: The screw should be secured tightly after replacing the
batteries.
Install the batteries in the correct assembly. When re-insert reflector set,
with smart design, please gently insert it, it could slowly slide into groove
and fit it well, please do not over-force on it. Closing the flashlight by
screwing the cap right to end of the screw thread.
Declaration of Conformity
This dectaration certifies compliance with the indicated directives but
implias no asaurance of properties.
Tha safety of the product information should be abservad.
This statement tums off automatically whenever changes are made to the product
that have not been matched with the company KSE-LIGHTS GmbH.
KSE-LIGHTS GmbH
Thungenteld 8
58256 Ennepetal
Genmany| Tel: —49 (0)2333-98247 30
Fax: -49 (0)2333-98247 49
www.kse-lights.com
infogoksetights.com
---|---
Bankverbindung:
Sparkasse Ennepetal Breckerfeld
IBAN:DE62 4545 1060 0000 0927 67
Swift/BIC : WELADED1ENE| Geschaftsfiihrer: Detlev Seel / Nikolai Seel
WEEE-fleg.-Nr.DE 270 590 52
Registergericht Hagen HRB 7367
Ust-ld Ne: DE 814 691 073
KSE-LIGHTS GmbH
Thüngenfeld 8, 58256 Ennepetal, Germany
Tel.: +49 2333 98247 30
Mail: info@kse-lights.com