KSE-LIGHTS KS-7090 Battery Operated Helmet Lamp User Manual
- June 12, 2024
- KSE-LIGHTS
Table of Contents
KSE-LIGHTS KS-7090 Battery Operated Helmet Lamp
Installation
Operation
Lighting by pushing the switch on the top of the lamp. By pushing it again, the different light modes are switched.
Safety Warnings
- The screws shall be secured tightly after opening and closing of the enclosure.
- Substitution of components may impair intrinsic safety.
- Clean the flashlight only with damp cloth to avoid static electricity.
- Do not flash the light beam directly into human’s eyes.
- Always use this flashlight by following regular and legal rules governed by industrial control and management authority from every country.
Specifications
Important
Read these instructions before use and maintain the flashlight for reference
Product
KS-7090 Industrial Flashlight for use in hazardous locations.
Type
Energizer E92
Duracell MN2400
Panasonic AAA LR03
Features
- Intrinsically safe for use in hazardous locations
- Functions: high and low mode
- Cree LED
- IP67
- Tough and durable casing
- Focus and flood reflector
- Build-in gas release vent
- High-Visibility yellow colour body
Certifications
-
Class I Div 1 & 2 Grp ABCD
Class II Div 1 & 2 Grp EFG
Class III Temperature Code: T4 IP67
File number: E324236 -
Ex ia IIC T4 Ga
IECEx UL 14.0059X -
II 1G Ex ia IIC T4 Ga
DEMKO 14 ATEX 1354X -
2813
DAY SUN TECHNOLOGY LTD
Address: 1st FL, No.1, Alley 2, Lane 110, Sec.4, Hsimen Rd.
North District, Tainan, 704 Taiwan
Standards
- UL 913 7 th Edition
- CSA C22.2 No. 157-92, Reaffirmed 2012
- EN 60079-0 : 2009 Edition
- EN 60079-11 : 2012 Edition
- EN 60079-26 : 2007 Edition
- IEC 60079-0 : Fifth Edition
- IEC 60079-11 : Sixth Edition
- IEC 60079-26 : Second Edition
Change of batteries:
Warning – Replace batteries only in non-hazardous areas.
Please loosen the four screws on the back and open the light body.
Always use the correct batteries, please do not mix different battery brands. Always replace all batteries at the same time.
Insert the batteries into the housing. Note the markings for the positive and negative terminals. Observe the following two rules:
- Only use Energizer E92, Duracell MN2400 or Panasonic AAA LR03 battery types.
- To avoid the risk of explosion, please do not mix new batteries or batteries from different manufacturers or of different types.
- If the lamp is not used for a long time, the batteries should be replaced to avoid leakage, which would affect the lamp life.
Warning: The screws should be secured tightly after replacing the batteries.
Insert the batteries into the correct assembly. Replace the back plate without applying too much force. Then tighten the four screws.
Declaration of Conformity
Customer Service
KSE-LIGHTS GmbH
Thüngenfeld 8, 58256 Ennepetal, Germany
Tel.: +49 2333 98247 30 • Mail: info@kse-lights.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>