JONATHAN Y JYL7581A Grace 36.5 Inch Pendants Instruction Manual
- June 12, 2024
- JONATHAN Y
Table of Contents
JONATHAN Y JYL7581A Grace 36.5 Inch Pendants
Model#: JYL7581A
Product Dimensions: 36″Lx7.75″Wx19″-49″H
WARNING
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
CARE AND MAINTENANCE
To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the surface of the fixture. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the interior surface of the fixture. Do not use any cleaners with chemical, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
NOTICE& IMPORTANT SAFETY INSTRUCTIONS
- Please make sure that you have all parts indicated before you begin assembly of this item.
- This item should be assembled on a soft surface to prevent scratching the finish during assembly.
- To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below for safe use and installation.
- The external flexible cable or cord of this lamp cannot be replaced
If the cord is damaged, the lamp shall be destroyed
PART LIST AND HARDWARE LIST
PIECE
|
DESCRIPTION
|
PICTURE
|
QUANTITY
---|---|---|---
A| Mounting plate| 
| 1X
B| Ground screw| | 1X
C| Outlet box screw| | 2X
D| Wire nut| | 5X
E| Anchor| | 4X
F| Tapping screw| | 4X
G| Electric cord| | 2X
H| Hex nut| | 3X
I| Spring washer| | 3X
J| Metal plate| 
| 1X
K| Canopy| 
| 1X
L| Swivel| | 3X
M| 6″ rod| | 6X
N| 12″ rod| | 6X
O| Fixture body| | 3X
P| Light bulb| | 3X
Q| Canopy nut| | 2X
R| Spanner| | 1X
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 20 minutes.
- Raise the 12″ rod (N) and 6″ rod (M) thread to the fixture body (O), then attach the swivel (L) to the rod (M)
- Unscrew the mounting plate (A) from canopy (K), attach the swivel (L) to the canopy (K), secure with metal plate (J), spring washer (I) and hex nut (H) by using the spanner (R).
- Pushing the hole and install the anchor (E) to the ceiling.
- Attach the mounting plate (A) to the junction box (not included) with the two outlet box screws(C), secure with tapping screw (F), then connect wires.,
Connect, Hot, Black or Red Outlet Supply Wire to:| Connect, Neutral, White Outlet Supply Wire to:
---|---
Black| White
- Parallel Cord (round & smooth)| * Parallel Cord (square & ridged)
Clear, Brown, Gold or Black without Tracer (colored stripes)| Clear, Brown, Gold or Black with Tracer (colored stripes)
Insulated Wire (not green) with copper metal conductor| Insulated Wire (not green) with Silver metal conductor.
*
Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left.)
Grounding Instructions:
a) For installation in the United States: Wrap ground wire from outlet
box around green ground screw (B) on mounting plate, no less than 2″ from wire
end. Tighten ground screw. If fixture is supplied with a ground wire, connect
to outlet ground wire with a wire nut.
b)** For installation in Canada: If fixture is supplied with ground wire,
wrap ground wire around green grounding screw on mounting plate. Tighten
ground screw.
- Raise the canopy (K) thread to the mounting screws, secure with canopy nut (Q)
- Install the light bulb (P) to the socket.
Specified on this fixture. Make sure that electrical current is turned off before changing bulbs.
PLEASE USE TYPE”A” BULB MAX 40-WATT OR CFL BULB MAX 13-WATT OR LED BULB MAX 9-WATT, THERE IS LED 4-WATT BULB IN THE BOX
Documents / Resources
|
JONATHAN Y JYL7581A Grace 36.5 Inch
Pendants
[pdf] Instruction Manual
JYL7581A Grace 36.5 Inch Pendants, JYL7581A, Grace 36.5 Inch Pendants, 36.5
Inch Pendants
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>