JONATHAN Y JYL7129A 30 Inch Bath Vanity Light Instruction Manual
- October 30, 2023
- JONATHAN Y
Table of Contents
Model : JYL7129A
Product Dimension: 30″Lx3.125″Wx4.375″H
Instruction Manual
WARNING
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN
INSTALLED.
CARE AND MAINTENANCE
To clean the outside of the fixture, use a dry or slightly dampened clean
cloth (use clean water, never a solvent) to wipe the surface of the fixture.
To clean the inside of the fixture, first disconnect power to the fixture by
turning off the circuit breaker or by removing the fuse at the fuse box. Next,
use a dry or slightly dampened clean cloth (use clean water, never a solvent)
to wipe the interior surface of the fixture.
Do not use any cleaners with chemical, solvents or harsh abrasives. Use only a
dry soft cloth to dust or wipe carefully.
NOTICE & IMPORTANT SAFETY INSTRUCTIONS
- Please make sure that you have all parts indicated before you begin assembly of this item
- This item should be assembled on a soft surface to prevent scratching the finish during assembly
- To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below for safe use and installation
- The external flexible cable or cord of this lamp cannot be replaced Ifthe cord is damaged, the lamp shall be destroyed
Part List and Hardware List
PIECE| DESCRIPTION| PICTURE| QUANTITY| PIECE|
DESCRIPTION| PICTURE| QUANTITY
---|---|---|---|---|---|---|---
A| wire connector| | 3X| E| ground screw| | 1 X
B| mounting bracket| | 1X| F| mounting screw| | 2X
C| machine screw| | 2X| G| the metal plate| | 2X
D| canopy| | 1X| | | |
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 20 minutes.
- Fix the mounting bracket(B) to the outlet box with mounting screw(F).
- Make wire connections, with wire connectors(A), following the reference chart listed below.
Connect, Hot, Black or Red Outlet Supply Wire to:| Connect, Neutral, White Outlet Supply Wire to:
---|---
Black| White
- Parallel Cord (round & smooth)| * Parallel Cord (square & ridged)
Clear, Brown, Gold or Black without Tracer (colored stripes)| Clear, Brown, Gold or Black with Tracer (colored stripes)
Insulated Wire (not green) with copper metal conductor| Insulated Wire (not green) with Silver metal conductor
*Note: When parallel wire ( SPT | & SPT Il ) is used. The neutral wire is
square shaped and ridged and the hot wire will be round in shape and smooth. (
See illustration on left. )
Grounding Instructions:
a) For installation in the United States: Wrap ground wire from outlet box
around green ground screw(E) on mounting bracket, no less than 2″ from wire
end. Tighten ground screw. If fixture is supplied with a ground wire, connect
to outlet ground wire with a wire connector.
b) For installation in Canada: If fixture is supplied with ground wire, wrap
ground wire around green grounding screw on mounting bracket. Tighten ground
screw.
- Carefully remove packaging from fixture, fix the canopy(D) to bracket(B) using machine screw(C).