Chargers ST-A112Q 3 In 1 Wireless Charging Station User Manual
- June 8, 2024
- Chargers
Table of Contents
3 IN-1
Wireless Charging Station (Model: ST-A112Q)
ST-A112Q 3 In 1 Wireless Charging Station
Adapter: Input: AC 100-240V 50-60Hz 0.5A (Max)
Output : DC 5V/3A(Max) 9V2.5A(Max) 12V/2A(Max)
Station : Input: DC5V/3A 9V/2A 12V/1.5A
Output :
Phone: 5W/7.5W/10W
Watch: DC5V/0.5A
Earphone: DC5V/0.5A
PART LIST
INSTALLATION NOTES
-
Roating the holder to match your phone’s wireless charging coil precisely on the center of the wireless charger.
-
Choose the right phone case, cases less than 5mm thick only.
-
Put your watch on the watch charger.
-
Put your AirPods on the AirPods holder.
-
LED Indicator description.
Charging Station Status| Indicator Status
---|---
Connected to power| Red and blue lights flashing
alternately for 3 s.
Phone charging normal| Solid Blue for 10 s, then off
Phone charging abnormal| Red and blue lights flashing
alternately
Charging Watch and earphone| No light display
WARM TIPS
-
- Keep in mind to charge your device before it runs out of power, otherwise it will shorten the working life of your devices.
-
Reach us by your Amazon order detail page (select “order” “sold by or “contact seller”) or contact us via email for warranty or customer services about it.
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to
the following two cond itions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Caution: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help important
announcement
Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
| 1 Year Warranty and Dedicated Customer Service
---|---
Service Email:
service@korybell.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>