Chargers OBCS01-BL Portable 3 In 1 Charging Station User Manual
- June 3, 2024
- Chargers
Table of Contents
Chargers OBCS01-BL Portable 3 In 1 Charging Station
PACKAGE CONTENTS
- 1x Charging Base
- 1x Watch Charger
1x 15W Wall Charger
1 x USB-A to USB-C Charger Cable
4x Nano Sticky Pads
INSTALLATION
Insert the watch charger into the base and make sure it is securely in place.
Connect your AirPods to the charger.
Put your iWatch on the charger.
Adjust the charging tab to upright.
Align your phone with the charging tab and plug it in, then adjust the stand to securely support your phone.
WARM TIPS
The phone holder is 0 to 120 adjustable.
You can place your phone horizontally to enjoy videos
To remove the watch charger, press the button on the back to the right and you
can easily take it off.
Please use the included adapter or certified adapters (above 12W).
The double-sided adhesive pads can be used too secure the charging station toa tabletop, so that you can pick up your phone and AirPods with one hand easily
You are anytime welcomed to contact us for product warranty or any support, please follow the methods below:
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following fwo cond
itions: (1) this device may not cause harmful interference, and (2) this
device must accept any inte rference received, including interference that may
cause undesired operation. Caution: Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment. NOTE: This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help important announcement
- Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.