Chargers JJT-A80 4 In 1 Fast Wireless Charger User Manual
- October 30, 2023
- Chargers
Table of Contents
Chargers JJT-A80 4 In 1 Fast Wireless Charger User Manual
1. Product Introduction
This product is a 4-in-1 fast wireless charger that simultaneously wirelessly
charges phones /Apple Watch/TWS Bluetooth AirPods. that support the Ql
standard. This product also adds the night atmosphere light design, is a
convenient and practical intelligent electronic device.
This product has a folding design. The folding way of the product makes it
easier to store and carry; Open the charging panel state can charge multiple
devices at the same time. You can charge your device wirelessly by placing it
in the charging zone.
You can put the phone vertically or horizontally, without affecting the
charging of the phone, while charging, you can video chat or watch your
favorite movie or TV.
Two. specification parameters
Three. operation steps
-
When wireless charging other devices, please first power the product through the equipped charging
-
Press the switch button of atmosphere light to turn on the 1st level atmosphere light; Press the switch button again to turn on the second gear of the environment light, and press the switch button three times to turn off the atmosphere light and repeat theT IT Ax Aligned word
-
When charging a device such as a phone, iWatch or Bluetooth headset, place the phone, iWatch or Bluetooth headset flat in the charging area and after 0.1 seconds, start charging the device; When fully charged, you can directly remove the device; During charging, if the device needs to terminate charging, it can be removed
-
When the product is turned over, the mobile phone can be placed horizontally/vertically to charge.
-
The product can be folded for easy storage and portability
Four. precautions
- Do not immerse the product in water to avoid short circuit of the internal
- Do not disassemble or break the product by yourself, so as not to cause product
- Please keep the product away from flammable and explosive liquids, gases or
Do not place magnetic cards, magnetic strip media and precision machinery too close to the product.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the users authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference wil not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm
between the radiator & your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.