Chargers W18 7.5W Wireless Charger for iPhone User Manual

June 4, 2024
Chargers

Chargers -logo

Chargers W18 7 5W Wireless Charger for iPhone- Wireless Charger

Applicable devices

Devices which wireless charging received built-in:

  • 7.5W for iPhone
  • All Qi-enabled phones and devices.

Specification

Model: W18
Material: ABS+PC+METAL
Input: 18W 9V/2A
Output iPhone: 7.5W
Charging Distance: 7mm
Conversion efficiency:= 75%
Working frequency: 110.5- 205
KHz

Chargers W18 7 5W Wireless Charger for iPhone-fig1

Attention

  • Please use 9V/2A adapter and high-quality cable to ensure a charging effect;
  • Keep your device dry, Do not put it into water or any other liquid Do not make it wet.
  • Do not lay the magnetic card, magnetic record media, and precise machine too close to the protection.
  • Do not let the dust or other things accumulate on the product and the Type-C input port.
  • Keep out of reach of children.

Packaging listing:

1 wireless charging stand
1
Type-c cable
1 Adapter
1
User manual

Magsafe case compatible

Chargers W18 7 5W Wireless Charger for iPhone-fig2

Common problems

Problem Cause Solution
Smartphones cannot be charged The wireless charger is detecting the input
power of the smartphone and adjusts the output power compatible with it.

Please remove the phone for a few seconds or unplug the power and reconnect it.

Battery health
In order to slow down the aging of the battery, iPhone will learn your daily charging mode and temporarily delay charging to more than 80% until you need it.

FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
Product Model: W18 PMN: wireless charger
ISED STATEMENT
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. During the operation of the device, a distance of 10 cm surrounding the device and 10 cm above the top surface of the device must be respected.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals