OUTWATER BP-DW4-BLK Barn Door Hardware Classic Strap Instruction Manual
- June 12, 2024
- OUTWATER
Table of Contents
BARN DOOR
HARDWARE
CLASSIC STRAP
Bypassing hardware kit for double sliding wood doors.
MODEL No. BP-DW4-BLK
INSTALLATION MANUAL
INCLUDED IN KIT
A| Door Roller Hardware| x4| F| ST8x90 Bolt + Washer| x10| K| 2.5mm Allen
Keys| x1
---|---|---|---|---|---|---|---|---
B| M8x60 Bolt| x10| G| Routed Floor Guide| x2| L| Anti-Jump Disk| x4
C| M8x30 Wall Anchor| x10| H| Floor Anchor| x4| M| M8x60 Bolt + Nut| x5
D| Wall Bracket| x10| I| ST4.2×25 Screw| x4| N| M8x60 Bolt + Washer| x10
E| 78 3/4″ Rail| x2| J| Door Stop| x4| O| Bypassing Bracket| x5
TOOLS REQUIRED
• Plumb Line
• Pencil
• Phillips Head Screwdriver
• 8mm Drill Bit
• 5.5mm Drill Bit| • 10mm Routing Drill Bit
• Wrench
• Level
• Tape Measure
• Power Drill
---|---
BYPASSING CLASSIC STRAP
NOTES
To obtain maximum weight capacity, all fasteners must be mounted into solid
wood studs or wall blocking or mounted to a header board.
Consult a structural engineer if you have questions about what type of wall
blocking is required.
Find the
centerline of the track. Using a level, mark a horizontal line twice the door
width long. Mark the bracket screw locations into the wall blocking. Attach
the wall portion of the brackets as shown.
Insert the door stops to the rail. One at each end, then attach the rail to
the wall brackets using a wrench to fasten the bolts as shown.| Drill out
holes in the doors using a 10mm routing drill bit as pictured. The bottom of
the doors should be routed at this time in order to accept the floor guide.
---|---
Attach the anti-jump disks to the tops of the door.| Attach the door to the
rails making sure that the anti-jump disks are engaged to avoid a serious
accident.
---|---
Use a wrench to attach the bypassing brackets to the wall and rail as
pictured.| Insert the door stops to the rail. One at each end and attach the
second rail to the bypassing brackets as shown.
---|---
Attach the door to the rails making sure that the anti-jump disks are engaged
to avoid a serious accident.| Plumb the door and mark the positions of the
floor guides.
Mount the floor guides to the floor.
---|---
Adjust the door
stops accordingly using the provided 2.5mm Allen key.
Install the end
cap covers.
Architectural Products by Outwater assumes no liability for improper installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>