Chargers T3 Magnetic Wireless Car Charger User Manual

Chargers T3 Magnetic Wireless Car Charger

How to install it?

• Step 1: Peel off the paper of 3M adhesive pad.

• Step 2: Stick it on the back of car screen or anywhere you want.
  Then adjust the length and angle to what you want.

• Step 3: Put your phone on the mount.

  • A: For iPhone 12/13/14 series, directly put your phone on the mount.
    NOTE: Please match the MagSafe area to the magnet area of the mount.

  • B: If your iPhone has MagSafe case and the magnet is not strong enough.
    Please stick the metal ring on the back of the case, then put your phone on the mount.

Wireless Charge

Plug the Type-C cable to the wireless car charger mount and plug the other end to the car charger or Type-C port on the center console.

Note: Wireless charge only work with iPhone 12/13/14 series.

Safety Caution:

• Please confirm the appropriate place to use. Act contrary to public order is prohibited.
• After you install the car phone mount on your car, please wait it for 24 hours to use it.
• Do not disassemble or modify this product by yourself.
• Do not hit or throw this product, or it would be prone to internal malfunction.
• Do not place the product in a low-temperature, humid place.
• Do not throw the product into fire. Please keep it away from fire.
• warning: This product is not suitable for children no more than 3 years old to use individually.

FCC statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>