PRINTEK I80 Interceptor 80 Barcode Label Printer User Guide
- June 4, 2024
- PRINTEK
Table of Contents
I80 Interceptor
80 Barcode Label Printer
User Guide
I80 Interceptor 80 Barcode Label Printer
This guide provides information on the daily use of the I80 printer.
For additional information, please refer to the I80 User Guide.
Before you begin, please visit www.printek.com Mobile Printers; Service and Support; Drivers and Software, to download the I80 printer driver.
Printer features
Media (8.5’’)
The printer can accept roll paper, fanfold, or single sheet paper.
LOADING PAPER :
Roll Paper –
- Open the paper door by inserting your finger into the cutout in the paper door and gently pulling the door toward the front of the printer.
- Insert the leading edge of the paper roll into the printer with the coated side down.
- Close the paper door and push the paper feed button to insure the paper is under the roller and able to advance.
Black Mark Paper –
- Open the paper door by inserting your finger into the cutout in the paper door and gently pulling the door toward the front of the printer.
- Insert the leading edge of the paper roll into the printer with the black mark facing up.
- Close the paper door and push the paper feed button to insure the paper is under the roller and able to advance. If the printer is properly configured for Black Mark paper the paper should advance until the black mark is detected by the printer.
Single Sheet Paper –
- Insert the single sheet of paper with the coated side down into the top of the printer.
- The printer will grab the single sheet and place it into the printer ready to print.
- If the printer has received a print job, the printer will begin to print as soon as the paper is detected.
Control Panel indicators
Control Panel
Control Panel
Power Button| Power Up
Power Down
Toggle IP over USB
on/off| Press & Release Press & Hold
Press twice
Paper Feed Button| Advance paper Print Setup Report| Press once(LF) or long
(FF) Press twice
Power & Status (Green/Red)| ( Yellow)| Alert (Red)|
Indication
On| Off| On| Booting up(… 20 sec!)
On| Off| Off| Ready
On| Off| Flashing| Paper Error/Lid Open
Flashing| Off| Off| Job is arriving
Flashing| Off| Off| Job is printing
Flashing| Off| Flashing| IP over USB active
Flashing| Flashing| Flashing| Restart the printer manually
Off| Off| Flashing| Restore the printer firmware
Off| Off| On| Print head too hot
Self-Test / Configuration print out
With power on, press the Paper Feed button twice quickly.
Accessing the Configuration Menus through USB
-
Turn the printer ON.
-
Connect a USB cable between the printer and a PC.
-
To access the I80 web page, push the Power button twice rapidly. This will put the printer into Configuration mode.
-
When the printer is in Configuration mode the POWER and FAULT LEDs will flash together.
A. Open the browser on your PC and type 169.254.200.1 into the address bar of the browser and hit Enter – A login box should appear:
B. Type “0000” and hit Enter- you should now be at the home page for I80 Configuration. -
Push the Power button twice rapidly to exit Configuration Mode.
Once the printer is connected via USB and in IP over USB mode it is temporarily not possible to access the Internet.
© 2021 Printek LLC 3515 Lakeshore Drive, St. Joseph, MI 49085
PH:800.368.4636
www.printek.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>