Ford 2016 Truck Explorer 2WD V6-3.5L Power Roof Opening Panel Instruction Manual
- June 3, 2024
- Ford
Table of Contents
2016 Truck Explorer 2WD V6-3.5L
Power Roof Opening Panel
Instruction Manual
2016 Truck Explorer 2WD V6-3.5L Power Roof Opening Panel
POWER ROOF OPENING PANEL INSTALLATION
2076 Explorer, Police Interceptor – Utility
507-77 Roof Opening Panel
General Procedures
Power Roof Opening Panel Installation
INSTALLATION
WARNING: Keep objects and body parts clear of the glass panel when
carrying out the installation procedure. During the installation procedure,
the glass panel closes with high force and cannot detect objects in its path.
Failure to follow this Installation may result in serious personal injury.
NOTE: Sliding Glass Panel Initialization
NOTE: The roof opening panel motor must be installaed when repairs are
carried out on the roof opening panel system, including any time the roof
opening panel motor has been removed, the roof opening panel glass (fixed
panoramic or sliding) has been removed or adjusted, or if the roof opening
panel frame has been removed.
NOTE: If Installatingboth roof opening panel motors, initialize the
sliding glass motor before Installating the shield motor.
A new sliding glass panel motor will only move to the vent position and must
be initialized.
-
NOTE : The driver or passenger front door must be open during the entire procedure. Open the driver or passenger front door.
-
Place the ignition switch in the ON position.
-
NOTE : Complete the following within 5 seconds:
1. Cycle the ignition switch to the OFF position and then back to the ON position.
2. Press the TILT control switch for less than one second and release.
3. Push and hold the TILT control switch until the sliding glass moves to the fully open and the back to the fully closed position (this could take up to 20 seconds to start). -
Release the control switch and verify successful initialization by carrying out the one-touch operations.
INSTALLATION
NOTE: Shield Installation
NOTE: If initializing both roof opening panel motors, initialize the
sliding glass motor before installaing the shield motor.
A new shield motor only moves toward the closed position and must be installad
-
NOTE : The driver or passenger front door must be open during the entire procedure. Open the driver or passenger front door.
-
Place the ignition switch in the ON position.
-
With the shade in the fully open position, pull and release the shade control switch closing the shade to the halfway position.
-
NOTE : Complete the following within 5 seconds:
1. Cycle the ignition to the OFF position and then back to the ON position.
2. Pull the shield control close switch for less than one second and release.
3. Press and hold the shield control close switch until the shield moves to the fully open position and then back to the fully closed position (this can take up to 20 seconds to start). -
Release the control switch and verify successful installation by carrying out one-touch operations.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>