JENSEN JS65T Triaxial Series Car Audio Speakers Owner’s Manual
- June 4, 2024
- Jensen
Table of Contents
JS65T Triaxial Series Car Audio Speakers
Owner’s Manual
PREPARATION
Safety Guidelines
Thank you for purchasing the Jensen JS Triaxial Series Car Speakers. Although
Jensen has attempted to make sure all of the information contained within this
manual is accurate, please be aware that any part of it is subject to change
without notice.
CAUTION The following instructions should be used as a general guideline
only. If you are unsure about performing any of the procedures listed below,
please consult a professional car audio installation center.
Before installation, please follow these guidelines:
-
Be sure to carefully read and understand the instructions before attempting to install this product.
-
For safety, disconnect the negative terminal from the battery prior to beginning the installation.
-
To ensure an obstacle-free fit, check and double-check the mounting depth of the speakers against available depth, as well as the location of window mechanics, door handles, and window handles.
-
Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines, or electrical wiring when working on any
vehicle. -
Never run speaker wires underneath your vehicle. Running speaker wires inside the vehicle provides the best protection from exhaust heat and environmental elements.
-
Avoid running wires over, near, or through sharp-edged surfaces. Use rubber grommets to protect any wires routed through metal.
-
When running the speaker cable from the amplifier, avoid running it near sources of high current (i.e. wiring harnesses, battery cables).
-
If using provided grilles, be sure the mounting location is sufficient distance from the door and/or window handles.
INSTALLATION
Basic Installation Steps
Step 1: Remove the existing speaker.
Step 2: Position the new speaker and align it with the existing mounting
holes.
Step 3: Attach the positive (+) and negative (-) speaker terminals (see
FIGURE 2). Be sure to observe proper polarity when connecting the wires (the
striped wire is the negative lead).
FIGURE 1 – DOOR PANEL INSTALLATION| FIGURE 2 – CONNECTING SPEAKER
WIRES| FIGURE 3 – REAR DECK INSTALLATION
---|---|---
| 
| 
-
Connect the speaker outputs from the head unit to the speakers.
-
In some vehicles, it may be possible to utilize the existing speaker wiring. When doing this, be cautious of the polarity (+/-) of the speaker wires, as these wire colors vary for each vehicle.
Tip: Using factory wiring harness adapters for the head unit and speakers can help eliminate wiring issues. -
In some vehicles, it may be necessary to run new speaker wires throughout the vehicle. Observe caution when routing wires.
-
Always use quality connectors that fit tightly, or solder each connection. It may be necessary to waterproof connections made inside door panels.
-
Wiring speakers out-of-phase (the polarity of one speaker is wrong) will cause the speakers to sound poor and have very little bass response.
Mounting
-
Determine where the speakers will be mounted. Make sure the area is large enough for the speaker to mount evenly. Also, ensure the mounting location is deep enough for
the speaker to fit. -
Refer to the specification chart to determine the proper diameter hole to cut for your speaker model.
-
If needed, use the grille as a template to mark the locations for the mounting screws. Drill the holes with a 3/32″ bit.
-
Fit the speaker to the hole cut-out. Mount the speaker using the supplied screws. If the speaker grille is to be used, insert 4 screws into the grille insert holes, and then mount the speaker.
Typical Door Installation ( Top – mount )
OPERATION
Specifications
The above diagram is to be used with
the specifications matrix guide below. Design and specifications are subject
to change without notice.
Model
|
Size
|
Type
| Power Rating (RMS/Peak)|
Sensitivity
|
Frequency Response
|
Cutout Diameter
| Top Mounting Depth| Bottom Mounting Depth|
Mounting Height
|
Tweeter Height
---|---|---|---|---|---|---|---|---|---|---
JS65T| |
3-Way
| 50W/250W| 87dB| 70Hz-
20kHz
| 5.59″| 2.28″| 2.44″| 0.67″| 0.51″
JS68T| 5″x 7″
6″x 8″
| 3-Way| 50W/250W| 87dB| 70Hz-
20kHz
|
4.95″ x 7.11″
| 2.22″| 2.59″| 0.65″| 0.28″
JS69T| 6″x 9″| 3-Way| 75W/375W| 89dB| 50Hz-
20kHz
|
5.95″ x 8.70″
| 3.11″| 3.56″| 0.87″| 0.42
SPECIFICATIONS & FEATURES
**** Speaker Size
RMS / Peak Power Woofer Surround Type| JS65T
6 1/2″
50W / 250W
Nitrile Butadiene Rubber| JS68T
5″ x7″ / 6″ x8″”
50W / 250W
Nitrile Butadiene Rubber| JS69T
6″ x 9″
75W / 375W
Nitrile Butadiene Rubber
---|---|---|---
Woofer Material| IMPP| IMPP| IMPP
Midrange Size| 35mm| 35mm| 58mm
Midrange Material| PEI| PEI| Mylar dome
Tweeter(s) Size| 15mm| 15mm| 20mm
Tweeter(s) Type| Piezo| Piezo| Piezo
Voice Coil Type| TSV| TSV| TSV
Voice Coil Size| 25mm| 25mm| 35mm
Sensitivity| 87db| 87db| 89db
Frequency Response| 70-20khz| 70-20khz| 50-20khz
Nominal Impedance| 4ohms| 4ohms| 4ohms
Grilles Included| Yes| No| Yes
WARRANTY
Limited One-Year (Or Two Year*) Warranty
This warranty gives you specific legal rights. You may also have other rights
which vary from state to state. Namsung America Inc warrants this product to
the original purchaser
to be free from defects in material and workmanship for a period of one year
from the date of the original purchase.
Namsung America Inc agrees, at our option, during the warranty period, to
repair any defect in material or workmanship or to furnish an equal new,
renewed or comparable
product (whichever is deemed necessary) in exchange without charges, subject
to verification of the defect or malfunction and proof of the date of
purchase. Subsequent replacement products are warranted for the balance of the
original warranty period.
Who is covered? This warranty is extended to the original retail
purchaser for products purchased from an authorized JENSEN dealer and used in
the U.S.A.
What is covered? This warranty covers all defects in material and
workmanship in this product. The following are not covered: software,
installation/removal costs, damage resulting from accident, misuse, abuse,
neglect, product modification, improper installation, incorrect line voltage,
unauthorized repair or failure to follow instructions supplied with the
product, or damage occurring during return shipment of the product. Specific
license conditions and copyright notices for the software can be found via
www.jensenmobile.com.
Warranty Coverage*
Limited 1-year warranty when purchased from an authorized Jensen dealer.
orLimited 2-year warranty when purchased from and professionally installed by
an authorized Jensen dealer.(Proof of purchase and Installation required)
What to do?**
- Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls may save you a service call.
- If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center.
- Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment.
- For more information and for the location of the nearest authorized service center, please contact us by one of the following methods:
• Call us oll-free at 888-921-4088
• E-mail us at cs@jensenmobile.com
Exclusion of Certain Damages: This warranty is exclusive and in lieu of
any and all other warranties, expressed or implied, including without
limitation the implied warranties
of merchantability and fitness for a particular purpose and any obligation,
liability, right, claim or remedy in contract or tort, whether or not arising
from the company’s
negligence, actual or imputed. No person or representative is authorized to
assume for the company any other liability in connection with the sale of this
product. In no event
shall the company be liable for indirect, incidental, or consequential
damages.
Customer Support
1-888-921-4088
(Monday-Friday, 9 AM-5 PM EST)
https://www.jensenmobile.com
Designed and Engineered in USA
Namsung America Inc.
©2021 Namsung America
Inc. All rights reserved.
All rights reserved. No part of this publication may be reproduced,
distributed, or transmitted in any form or by any means, including
photocopying, recording, or other electronic or mechanical methods, without
the prior written permission of NAMSUNG AMERICA INC.
NSC0921-V01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>