CANARMNA Bathroom Accessories And 3 Light Vanity Instruction Manual
- June 6, 2024
- CANARMNA
Table of Contents
BATHROOM ACCESSORIES AND 3 LIGHT VANITY
NEED HELP?
Call or Email us first
Our service team is ready to answer your questions…
1-800-265-1833 (English) /
1-800-567-2513 (French) IN CANADA –
ressalescanada@canarm.ca – IN USA –
ressalesusa@canarm.ca
Monday-Friday
8AM – 5 PM E.S.T
INSTRUCTIONS PERTAINING TO RISK OF INJURY TO PERSONS
READ ALL INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED:
SAFETY PRECAUTIONS:
- TURN OFF ELECTRICAL POWER BEFORE STARTING THE INSTALLATION OF THE LIGHT FIXTURE.
- WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- ENSURE THE SCREWS AND WALL PLUGS ARE SUITABLE FOR THE WALL INTENDED TO MOUNT THIS PRODUCT. CONSULT THE QUALIFIED PERSON FOR SAFETY INSTALLATION.
- TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
NOTE: The product may not look exactly as shown in the figures.
INSTALLATION:
-
Attach Easy Connect™ mounting bracket to the electrical box with electrical box screws (not included).
-
Option 1: Connect (push) electrical wires from the electric box (house wiring) into correct inserts.
Option 2 : For multiple green (ground), black (life) and white (neutral) wires joined in the electrical box (house wiring), attach a single “green”, “black” and “white” jumper wire before connecting. Strip 7mm from the 6” jumper wires supplied. Then connect (push) wires into the correct inserts.
-
Connect (push) electrical wires from fixture into correct inserts.
-
Attach fixture to the mounting bracket by tightening the 2 screws.
-
Remove spanner nut from a socket. Position the glass on the lamp and secure it with a spinner nut.
-
Install proper bulb type and wattage (not included).
- For the 24” towel bar, measure the distance (21 5/8” (549mm) ) between the hole centers on the back of the towel bar.
- Loosen the set screw to remove the mounting bracket before installing.
- Mark the wall for the pilot hole locations. Drill 7/32 inch pilot holes at the location.
- Install the mounting bracket to the wall with the wood screws and wall plugs.
- Mount the bath accessory onto the screws fitted to the wall. Secure it by the set screw with the tool supplied.