CANARMNA IOL609 Easy Connect Wall Light Instruction Manual

Table of Contents

CANARMNA-IOL609-Easy-Connect-Wall-Light-product

Specifications

Safety Precautions

Turn off electrical power before starting the installation of light fixture.
Use wiring supplies as required by local electrical code.
Product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product.
To clean the fixture, turn off the power, wait for it to cool, and wipe the fixture with a clean, soft cloth.

Installation Steps

Attach the Easy ConnectTM mounting bracket to the electrical box using electrical box screws (not included).
Option 1: Connect electrical wires from the electric box (house wiring) into the correct inserts (White – Neutral, Black – Live, Green – Ground).
Option 2: If multiple wires are joined in the electrical box, use a single jumper wire for Green, Black, and White wires before connecting.
Connect electrical wires from the fixture to the correct inserts.
Tuck electrical wires into the electrical box and position the fixture over the studs on the mounting bracket assembly. Secure with rubber washers and cap nuts.
Install specified bulb type and wattage (not included).
After installation, seal around the top and side perimeter between the fixture and the wall surface with weather-resistant caulk. Leave the bottom un-caulked to prevent moisture build-up.

Q: Can I use a different type of bulb than specified?
- A: It is recommended to use the specified bulb type and wattage for optimal performance and safety.
Q: Is weather-resistant caulk necessary for installation?
- A: Yes, using weather-resistant caulk is important to protect the fixture and prevent moisture damage.
Q: What should I do if the product looks different from the figures?
- A: Product appearance may vary slightly; refer to the written instructions for accurate installation.

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

TURN OFF THE ELECTRICAL POWER BEFORE STARTING THE INSTALLATION OF THE LIGHT FIXTURE.
WIRING SUPPLIES AS REQUIRED BY LOCAL ELECTRICAL CODE.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.

NOTE: Product may not look exactly as shown in figures

Attach the Easy Connect™ mounting bracket to the electrical box with electrical box screws (not included).
Option 1: Connect (push) electrical wires from the electric box (house wiring) into correct inserts.
- Option 2: For multiple green (ground), black (live) and white (neutral) wires joined in the electrical box (house wiring), attach a single “green”, “black” and “white” jumper wire before connecting. Strip 7mm from the 6” jumper wires supplied. Then connect (push) wires into the correct inserts.
Connect (push) electrical wires from fixture into the correct inserts.
Tuck electrical wires into the electrical box and position the fixture over studs on the mounting bracket assembly. Secure the fixture in place with rubber washers and cap nuts.
Install specified bulb type and wattage (not included). $CANARMNA-IOL609-Easy-Connect-Wall-Light-fig $3$$
After installation, seal around the top and side perimeter between the fixture and the wall surface with weather resistant caulk. The bottom should be left un-caulked to prevent moisture build-up. $CANARMNA-IOL609-Easy-Connect-Wall-Light-fig $4$$