CANARMNA Pendant Light Instruction Manual
- June 6, 2024
- CANARMNA
Table of Contents
CANARMNA Pendant Light
INSTRUCTIONS PERTAINING TO RISK OF
FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
TOOLS AND MATERIALS REQUIRED
Wiring supplies as required by local electrical code
SAFETY PRECAUTIONS
- TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
- TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A CLEAN, SOFT CLOTH.
- CLEAN GLASS WITH WATER ONLY.
NOTE: Product may not look exactly as shown in figures.
INSTALLATION
-
Install the length of rod that is required by threading wire through the rod and screwing it to the fixture. Install swivel to the rod, ensuring that the sleeve is at the swivel.
-
NOTE: Refer to the style of assembly that matches the style of your fixture.
Style#1-2: Mount the mounting bracket to electrical box using electrical box screws (not included). Make sure the studs on the mounting bracket are facing out from the electrical box.
-
Connect the ground wires (bare copper or green) from your fixture to the ground wire (bare copper or green) or ground screw in the electrical box. Connect the black wire from the fixture to the black wire in the electrical box and connect the white wire from the fixture to the white wire in the electrical box.
-
Once connections of wires are completed, carefully tuck wires and wire nuts into the outlet box making sure no bare wire (on the black and white) is visible at the wire nuts.
-
Style#1: Tuck electrical wires into electrical box and position fixture over studs on mounting bracket assembly. Secure fixture in place with star washer(s) and cap nut(s).
Style#2: Attached fixture to mounting bracket by tightening the 2 screws. -
Style#1: Remove spinner nut from socket. Position shade on lamp and secure with spinner nut.
Style#2: Remove the finishing screws that are already on your fixture. Position glass in place and secure with finishing screws.
Style#3: Remove spinner nut from socket. Position glass on lamp and secure with spinner nut.
-
Install proper bulb type and wattage (not included).
-
Install the glass by 3 screws as shown.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>